2. Razor
  3. MX500
MX500

Razor MX500 Operating instructions

  • Hello! I've reviewed the rear wheel replacement instructions for the Razor MX500 and MX650 models. This document provides a step by step guide to replace the rear wheel and includes important safety instructions. I'm ready to answer your questions about this procedure and the device, just ask!
  • What tools are required for the rear wheel replacement?
    What is the first step in the rear wheel replacement process?
    What should I do before starting any assembly or maintenance procedure?
    What should I do after reattaching the chain guard?
1
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
MX500/MX650 REAR WHEEL
REPLACEMENT INSTRUCTIONS
PART# W15128190048
Using a Phillips screwdriver, loosen screws and
remove chain guard.
Push the chain tensioner down to loosen the chain
and remove the chain from the wheel sprocket
and motor sprocket. Push and remove the wheel
downward.
Note: Your hands will get greasy doing this.
A. Two (2) 19 mm Wrenches
B. Phillips screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any
assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Using two (2) 19 mm wrenches, loosen both axle nuts.
Note: the arrangement of the hardware sequence:
Right Side (Throttle)
16-1 Nut
16-2 Washer
Frame
16-3 Spacer
Step 1
Step 3
Required Tools: (Not included)
WARNING
Step 2
Step 4
16-1
16-1
16-2
16-2
16-3
16-3
Left Side (Brake)
16-1 Nut
16-2 Washer
Frame
16-3 Spacer
2
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
MX500/MX650 REAR WHEEL
REPLACEMENT INSTRUCTIONS
PART# W15128190048
Install the new chain or wheel by slipping the chain
around the axle. Slide the axle into the slots on the
frame. Slide the chain tensioner down and maneuver
the chain onto the rear sprocket and motor sprocket.
Reattach the chain guard. Test ride and check.
Readjust as needed.
Step 5 Step 6
Attention: Charge battery for 12 hours before using.
/