Danfoss ESMD Installation guide

Danfoss
Brand
Danfoss
Model
ESMD
Type
Installation guide
ENGLISH
ESMD
1. Drill a 6.5 mm hole in the middle
of the air duct at a place where the
temperature sensor is not influenced
by stratified air, heat or humidifiers.
Place the temperature sensor in the air
duct (A).
2. Drill two 4 mm holes though the
flange holes (B) of the ESMD.
It is recommended to mount the ESMD
with the cable inlet facing down.
Use two 5 mm self-cutting screws (not
delivered) for mounting the ESMD.
3. Make a small hole in the black rubber
cable inlet and put the cable through
the inlet (C).
Press the orange tabs to connect wires.
Polarity not important.
4. Mount white front cover onto the
ESMD.
DANSK
ESMD
1. Bor et 6.5 mm hul i midten af
luftkanalen på et sted, hvor
temperaturføleren ikke påvirkes
af lagdelt luft, varme- eller
fordampningsflader.
Placér føleren i luftkanalen (A).
2. Bor 2 stk. 4 mm huller gennem ESMD
følerens flangehuller (B).
Det anbefales at vende kabel-
indgangen på ESMD føleren nedad.
Anvend 2 stk. 5 mm selvskærende
skruer (ikke medleveret) for fastgørelse
af ESMD føleren i luftkanalen.
3. Prik hul i den sorte gummitylle i kabel-
indgangen og før kablet igennem (C).
Tryk på de orange paler for tilslutning
af ledninger. Polaritet er ikke vigtig.
4. Montér det hvide frontdæksel på ESMD
føleren.
© Danfoss | 2021.09 AN39112983089001-000101 | 1
ESMD
Installation Guide
2 | © Danfoss | DCS-SGDPT/DK | 2021.09 AN39112983089001-000101
*087H9342*
? ESMD: www.danfoss.com
? https://www.youtube.com/user/DanfossHeating
-> Playlists -> How-to Videos -> District Energy installation videos
Dimensions / dimensioner
Installation Guide, ESMD
  • Page 1 1
  • Page 2 2

Danfoss ESMD Installation guide

Danfoss
Brand
Danfoss
Model
ESMD
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents