Bluetooth pairing
1. Press and hold the remote control photo key for 3 seconds to start, the blue light will be
on for 3 seconds to enter the matching state, and the matching state indicator will flash blue
.
2. Turn on the mobile phone Bluetooth to enter the searching state, and click "Dispho" from
the searched device list. After the connection is successful, the blue light of the remote
control will be on for a long time.
Dispho
3. Take a selfie 4. How to use the tripod
(Optional )
Long press photograph key for 3 s,blue lamp will flicker for 2 times and then be o, which
means machine is shut down.
1. Watch your hands during use.
2. The product is not designed for children under 14 years old.Do not swallow it.
3. Do not dismantle or modify the product.
4. Do not store the product in a humid environment.
5. Keep the product away from heat sources.
6. Do not expose the product to water or other liquids in caseof damage.
Powering o
Warnings
Note:
1
2
3
4
5
6
Indicator lamp
Quick Start Guide
Tripod Selfie Stick
Charging Mode of Remote Controller
Connect the type-c interface charging, and the red light will be on for a long time during
the process of charging;the redlamp will be o automatically after charging is finished。
● Remote control range: 10 meters (when unobstructed)
● If the remote control is not used for 10 minutes, it will automatically enter the sleep
state. Wake it up by pressing the photo key and automatically resume the connection.
If the remote control is not used for 30 minutes, it will automatically shut down.
● When the battery power is less than 20%, the red light of the remote control will flash to
remind when using the selfie stick. Please charge it in time
● Always place the tripod on an even surface and make sure it is stable.Keep it away from
anything that could cause it fall over.
Usage method
2. Fix the phone
1. Using the selfie stick
Photo key
5. Use tripod(Optional )
Take o the remote control and press the white closing button at the bottom of the handle with your
finger to spring the tripod away. Pull the lower ring out of the tripod, then push the rod upward to
put the tripod on the horizontal plane.
Pulling out button
Closing button
1 2
3 4
Model No:WS-20020, WS-SM2011
FCC ID:UR9WS-20020