Raingler NETS GRIPS N210 Installation guide

Brand: Raingler NETS GRIPS

Model: N210

Type: Installation guide

2003 - 2009 Toyota 4Runner 4th Gen (N210)

Ceiling Attic Net Installation

NOTE: Many newer models have B-pillar handles and even overhead on the ceiling that can be used for some of the top

mounting locations. Check to see if you prefer to use these factory locations as the nets typically have enough adjustment

to allow for this option. If your vehicle does not have handles in desired locations or you prefer to install mounting points for

better fitment, please follow the below steps.

IMPORTANT: READ INSTRUCTIONS FULLY BEFORE STARTING

Time:

approximately 60 minutes

Paw Level:

Tools:

1. Ratchet or Wrench

2. 10MM socket/wrench

3. 14MM socket/wrench

4. Small flat blade and/or panel removal tool for removing access covers and releasing plastic snap divots.

866-905-7625 | Tech@RAINGLER.com | Raingler.com

*EZ install Ceiling Nets will not need any tools to

install and typically take about 10 minutes simply

installing on OEM handles or the C102 mounts

explained in Step 2 below.

* Your particular model may very slightly from these shown and may include additional

hardware that you don’t need. Please contact us for assistance if questions before

proceeding.

*Instructions show process for 2 and 3 row equipped models.

Step 1

D pillar mounting.

3rd row equipped models remove the plastic

upper seat belt bolt to access the 14mm black

bolt and remove.

2nd row equipped models may have mirrors on

the trim panels that can easily pop out.

866-905-7625 | Tech@RAINGLER.com | Raingler.com

Loosely pop back just the top of the upper D pillar trim

piece just enough to slide the C100XL behind the trim

and align the mounting hole to the seat belt bolt.

2nd row version 3rd row version

Reinstall with the D ring tether protruding over the top of the D pillar trim and reassemble.

3rd row version shown here.

866-905-7625 | Tech@RAINGLER.com | Raingler.com

Step 2

Above the ¼ window mounting

and optional B pillar forward

mounting.

Your model may have handles

here, plastic hooks, or nothing at

all.

If you have plastic hooks or

handles, remove the side pop out

cap and remove the Phillips or

10mm bolts and reassemble with

the C102 hardware as shown.

If you have nothing here, you will need to install the C100M

hardware set

See video here for details. https://vimeo.com/316655122

Line up this location last, once the net has been put into

location for the most exact alignment.

Step 3

Line up the ceiling net to the factory handles and

previously installed D rings. Adjust and center to tension

buckles and mounting straps in desired location.

866-905-7625 | Tech@RAINGLER.com | Raingler.com

Step 4

Tie up the loose ends. You can do this by feeding the end of the strap through the opening of

the buckle to create a loop. Feed the strap through the loop, and the strap behind, continue

until no strap is hanging.

See video here for details:

https://vimeo.com/316588617

Thank you for purchasing Raingler Nets.

If you have any questions please contact us,

we are here to help!

See all our install videos on Vimeo!

https://vimeo.com/raingler

1
2
3
4
5

Raingler NETS GRIPS N210 Installation guide

Brand: Raingler NETS GRIPS

Model: N210

Type: Installation guide

Download PDF

Related papers

Other documents