Metra 99-3000 Installation guide

Category
Car kits
Type
Installation guide

Metra 99-3000 is a dash kit that allows you to install an aftermarket radio into your 1988-1994 Chevrolet/GMC vehicle. It includes provisions for both DIN and ISO head units, and comes with all the necessary hardware for installation. The kit also includes detailed instructions and diagrams to help you with the installation process. With the 99-3000, you can easily upgrade your vehicle's audio system and enjoy your favorite music or podcasts while you're on the road.

Metra 99-3000 is a dash kit that allows you to install an aftermarket radio into your 1988-1994 Chevrolet/GMC vehicle. It includes provisions for both DIN and ISO head units, and comes with all the necessary hardware for installation. The kit also includes detailed instructions and diagrams to help you with the installation process. With the 99-3000, you can easily upgrade your vehicle's audio system and enjoy your favorite music or podcasts while you're on the road.

INSTALLATION INSTRUCTIONS FOR PART 99-3000
APPLICATIONS
METRA. The World’s best kits.
metraonline.com1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
REV. 10/5/2012 INST99-3000
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
• DINheadunitprovision
• ISOheadunitprovision
•A)Radiohousing•B)ISObrackets
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS(soldseparately)
WiringHarness:
•70-1858-GMharness1987-2005
AntennaAdapter:
•40-GM10-GMantennaadapter
•Panelremovaltool•Phillipsscrewdriver
•Smallflatbladescrewdriver•Cuttingtool•Scribe
TOOLS REQUIRED
Chevrolet/GMC 1988-1994
99-3000/AW-333GM
See application list inside
A B
99-3000
Applications
2
Table of Contents
Chevrolet
FullsizeBlazer..................................................... 1992-1994
Fullsizepickup..................................................... 1988-1994
Suburban.............................................................. 1992-1994
GMC
C-Series............................................................... 1988-1994
Suburban.............................................................. 1992-1994
Yukon................................................................... 1992-1994
-ChevroletSuburban1992-1994.........................................2
-GMCC-Series1988-1994..................................................2
-GMCSuburban1992-1994................................................2
-GMCYukon1992-1994......................................................2
Kit Assembly
-DINheadunitprovisions.....................................................3
-ISOheadunitprovisions.....................................................3
Table of Contents
Dash Disassembly
-ChevroletfullsizeBlazer1992-1994..................................2
-Chevroletfullsizepickup1988-1994.................................2
-ChevroletSuburban1992-1994.........................................2
-GMCC-Series1988-1994..................................................2
-GMCSuburban1992-1994................................................2
-GMCYukon1992-1994.................................................... xx
Kit Preparation
-ChevroletfullsizeBlazer1992-1994..................................2
-Chevroletfullsizepickup1988-1994.................................2
Dash Disassembly
(Figure A)
1. Pulloutonthebottomoftheradiotrimbezel.
Unhookthetopcornersofthebezelandremove.
(FigureA)
2. Removethemetalfasteningclipsfromthebottom
ofthefactorydashpanelandattachthemtothe
samelocationontheradiohousing(rearinside
cornerviewshown).(FigureB)
Continue to kit preparation
Dash Disassembly
(Figure B)
99-3000
3
1. RemovetheA/Cventsfromthefactorydashpanel
byreleasingthespringfasteningclipssecuring
themtothepanel.
2. Mounttheventstotheradiohousingbyinserting
theinneredgeoftheventintothecenterinside
pivotholeandtheouteredgeoftheventintothe
outerpivothole.
3. Usingthesamemetalspringclipsandmounting
proceduresfromtheoriginaltruckpaneltomount
theventstotheradiohousing.(FigureA)
Continue to kit assembly
Kit Preparation
(Figure A)
ISO head unit provision
1. MounttheISObracketstotheradiousingthe
screwssuppliedwiththeradio.(FigureA)
2. SlidetheradiointotheradiohousinguntiltheISO
bracketssnapintoplace.(FigureB)
3. Locatethefactorywiringharnessinthedash.
Metrarecommendsusingthepropermating
adapterfromMetraorAXXESS.Re-connectthe
negativebatteryterminalandtesttheunitfor
properoperation.
4. Reassembledashinreverseorderofdisassembly.
Kit Assembly
(Figure A)
DIN head unit provision
1. SlidetheDINcageintotheradiohousingand
securebybendingthemetallockingtabsoutward.
(FigureA)
2. Slidetheaftermarketradiointothecageuntilit
snapsintoplace.(FigureB)
3. Locatethefactorywiringharnessinthedash.
Metrarecommendsusingthepropermating
adapterfromMetraorAXXESS.Re-connectthe
negativebatteryterminalandtesttheunitfor
properoperation.
4. Reassembledashinreverseorderofdisassembly.
Kit Assembly
(Figure A)
RIGHT SIDE CLIP
right side clip
INSTALLATION INSTRUCTIONS FOR PART 99-3000
METRA. The World’s best kits.
metraonline.com1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
REV. 10/5/2012 INST99-3000
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Metra 99-3000 Installation guide

Category
Car kits
Type
Installation guide

Metra 99-3000 is a dash kit that allows you to install an aftermarket radio into your 1988-1994 Chevrolet/GMC vehicle. It includes provisions for both DIN and ISO head units, and comes with all the necessary hardware for installation. The kit also includes detailed instructions and diagrams to help you with the installation process. With the 99-3000, you can easily upgrade your vehicle's audio system and enjoy your favorite music or podcasts while you're on the road.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI