Origin Storage Thecus D16000 Installation guide

Thecus D16000
Brand
Origin Storage
Model
Thecus D16000
Category
NAS & storage servers
Type
Installation guide

This manual is also suitable for

D16000 Quick Installation Guide
The Thecus D16000 is a JBOD device to connect with Thecus N8900/N12000/N16000
series for storage capacity expansion via SAS wide port 8088 cable.
Please follow the steps below to start the installation of the D16000.
1. Connect the power cord to its redundant power supply
2. Connect the SAS-Wide port to “Host”, if there is a 2
nd
D16000 in daisy chain then
please connect it to “EXP”.
3. By using a coin or a screw driver, turn the yellow disk shown below to setup the
device ID. For all of the D16000 JBOD devices connect to a Thecus NAS, a unique
ID is required to recognize the differences in between each device.
4. Power on the D16000 JBOD device.
5. The front panel will display the following information
a. The device ID is 2
b. The system fan and temperature are healthy
c. The HDD light will stay red until all 16 disks have been installed
d.
The RDY light will turn on when the SAS wide port is connected
e. The ACT light will flash when there is I/O activity
  • Page 1 1
  • Page 2 2
  • Page 3 3

Origin Storage Thecus D16000 Installation guide

Thecus D16000
Brand
Origin Storage
Model
Thecus D16000
Category
NAS & storage servers
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents