KitchenAid WHBS 64 F LM X Setup and user guide
- Category
- Cooker hoods
- Type
- Setup and user guide
Thanks for choosing
Cooking gestures are
invisible ingredients.
They turn inspiration
into emotions and
emotions into a
masterpiece.
It’s all about artisanality,
that’s why we take it so
seriously.
Quick Reference Guide
Index
EN pag. 3
3
Hood
Quick reference guide
EN
Cooking gestures are
invisible ingredients.
They turn inspiration
into emotions and
emotions into a
masterpiece.
It’s all about artisanality
,
that’s why we take it so
seriously.
Thanks for choosing
4
Quick Guide
THANK YOU FOR BUYING A
KITCHENAID PRODUCT
In order to receive a more complete assistance, please
register your product on www . kitchenaid . eu/ register
Before using the appliance
carefully read the Safety
Instruction.
First time use
Air Vent (for the suction versions)
Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet
(connection ange).
Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the
suction performance and a drastic increase in noise.
Any responsibility in the matter is therefore declined.
! Use a duct of the minimum indispensible length.
! Use a duct with as few elbows as possible (maximum elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
! The company declines any responsibility whenever these regulations are not respected.
Filtering or ducting?
! Your cooker hood is ready to be used in suction version.
To use the hood in ltering version the special ACCESSORY KIT must be installed.
Check if the ACCESSORY KIT is furnished or must be bought separately.
Note: If furnished, in certain cases, the additional activated carbon ltering system may be installed
on the hood. Information about the conversion of the hood from suction version to ltering version is
present in the Manual “Safety Instructions & Installation”.
Ducting version
In this case the fumes are conveyed outside of the building by means of a special pipe connected with
the connection ring located on top of the hood.
Attention! The exhausting pipe is not supplied and must be purchased apart. Diameter of the
exhausting pipe must be equal to that of the connection ring.
Attention! If the hood is supplied with active charcoal lter, then it must be removed.
Filter version
The aspirated air will be degreased and deodorised before being fed back into the room.
In order to use the hood in this version, you have to install a system of additional ltering based on
activated charcoal.
Product Description
5
Controls
The hood is tted with a control panel with aspiration speed selection control and a light switch to
control cooking area lights.
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the
cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during
cooking and for another 15 minutes approximately after terminating cooking.
T1. ON/OFF light switch
T2. Speed 1/OFF switch
T3. 2-speed selection
T4. 3-speed selection
Technical data
Height (cm) Width (cm) Depht (cm) Ø of exaust tube (cm)
62-114 59,8 45,5 15
Cleaning and maintenance
Cleaning
• Do not use steam-cleaning equipment.
• Disconnect the appliance from the mains.
Important: do not use corrosive or abrasive detergents. If any such products unintentionally come into
contact with the appliance, clean the appliance immediately with a damp cloth. Do not use alcohol.
• Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing-up detergent to
the water. Finish off with a dry cloth.
Important: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin the
enamel surfaces.
Use detergents specically designed for cleaning the appliance and follow the manufacturer’s
instructions.
Important: clean the lters at least once a month to remove oil and grease residue.
Maintenance of the grease lters
This must be cleaned once a month (or when the lter saturation indication system - if envisaged on
the model in possession - indicates this necessity) using non aggressive detergents, either by hand or
in the dishwasher, which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease lter may discolour slightly, but this does not affect its
ltering capacity.
Pull out the handle to remove the lter.
Once the lter has been washed and left to dry, proceed in reverse order to ret the lter.
6
Active carbon lter (for models with ltering installation only)
The charcoal lter absorbs unpleasant odours caused by cooking.
The saturation of the charcoal lter occurs after more or less prolonged use, depending on the type of
cooking and the regularity of cleaning of the grease lter.
In any case it is necessary to replace the cartridge at least every four mounths (or when the lter
saturation indication system – if envisaged on the model in possession – indicates this necessity). The
charcoal lter may NOT be washed or regenerated.
Assembly
Hook the charcoal lter at the back on the metal tongue of the hood rst, then on the front with the
two knobs.
Disassembly
Remove the charcoal lter by turning the knobs xing it to the hood by 90°.
Replacing the lamps
The hood is equipped with an LED lighting system.
LEDs ensure excellent illumination, have a service life up to 10 times longer than traditional bulbs, and
offer up to 90% energy savings.
Note: For replacement LED, please contact the Technical After-sales Service Centre.
Troubleshooting
Problem Solutions
The appliance does not work. • Check the mains voltage and whether the appliance is
connected to the power supply;
• Check that a speed has been selected;
• Switch the appliance off and on again to see if the fault
persists.
The hood is not extracting air
sufciently.
• Check that the air extraction speed is set to the desired
level;
• Check that the lters are clean;
• Check the air vents for any obstructions.
The hood has turned off during
normal functioning.
• Check that the power has not been disconnected;
• Check that the omnipolar disconnection device has not
tripped.
7
Troubleshooting
Problem Solutions
The appliance does not work. • Check the mains voltage and whether the appliance is
connected to the power supply;
• Check that a speed has been selected;
• Switch the appliance off and on again to see if the fault
persists.
The hood is not extracting air
sufciently.
• Check that the air extraction speed is set to the desired
level;
• Check that the lters are clean;
• Check the air vents for any obstructions.
The hood has turned off during
normal functioning.
• Check that the power has not been disconnected;
• Check that the omnipolar disconnection device has not
tripped.
Please refer to our website www.kitchenaid.eu for complete instructions for use.
In addition, you will nd a lot more useful information about your products, such as inspiring
recipes created and tested by our brand ambassadors or the nearest KitchenAid cookery school.
EN
400011317343
Printed in Italy
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
KitchenAid WHBS 64 F LM X Setup and user guide
- Category
- Cooker hoods
- Type
- Setup and user guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Whirlpool WSLK651 Owner's manual
-
HOTPOINT/ARISTON HCT 64F L MS Setup and user guide
-
Hotpoint PCT 64 F L SS Setup and user guide
-
Whirlpool I CT 64LSS Setup and user guide
-
Bauknecht B CT 63F LS X Setup and user guide
-
Whirlpool WCT 64 FLS K Owner's manual
-
-
-
Whirlpool WHBS 93 F LK X Setup and user guide
-
Privileg DGHBS 64 LM X User guide