Anjielo Smart Tuya Smart Panel Firmware Upgrade Instructions Operating instructions

Hello! I've reviewed the user manual for the ANJIELO Tuya Smart Panel. This manual covers the installation of the device’s drivers, the firmware upgrade process, and provides guidance on switching the device to flashing mode. I am ready to assist with any questions regarding the setup and use of your device.
What is the first step in the driver installation?

How do I put the device into flashing mode?

What file format do I need for firmware upgrade?

www.anjielo.com whatsapp:+8615913473606 Email:[email protected]

Tuya Smart Panel

Firmware Upgrade Instructions

Install the driver (the process is as follows)

First unzip the two compressed files and install the driver

install driver

Click to install the driver

ANJIELOSMART

www.anjielo.com whatsapp:+8615913473606 Email:[email protected]

After the driver installation is complete, click to open this folder

Then click on the .EXE tool

Plug the device into the 220V power supply and turn it on, and connect it to the computer with a USB data

cable

ANJIELOSMART

www.anjielo.com whatsapp:+8615913473606 Email:[email protected]

After the connection is successful, the following screen will appear, and the computer screen will display 1

ADB device found

Click the switch button, the function of the switch button is to switch the device to the flashing mode

After the switch is successful, the device will restart, and a LOADER device will be displayed at this time,

indicating that the device has entered the flashing mode

ANJIELOSMART

www.anjielo.com whatsapp:+8615913473606 Email:[email protected]

Click to upgrade firmware

Click the firmware button to select the .img format firmware (if the firmware is in .rar or .zip format, you

need to decompress it first to get the .img format firmware).

ANJIELOSMART

www.anjielo.com whatsapp:+8615913473606 Email:[email protected]

Open the img file and wait for it to be loaded. Click Upgrade, and the download file will be displayed at this

time. After the progress of the firmware being downloaded reaches 100%, the device will restart after the

upgrade is complete.

The panel device automatically restarts and enters the system (it takes a little longer to enter the system for

the first time (about 5-10 minutes), just wait patiently)

ANJIELOSMART