RichardSolo JK005 User manual

  • Hello, I'm your chat assistant. I have reviewed the user manual for the RichardSolo 10000 mAh Dual Cable Power Bank. This document describes how to use the device's dual charging ports with built-in cables, monitor charge status with LED indicators, and ensure safe operation. I am ready to answer any questions you have about its features and usage.
  • How can I charge the power bank?
    How do I charge devices using the power bank?
    How can I check the remaining charge capacity?
Charging devices:
Connect attached micro-USB cable (1) to any micro-USB device*
For Apple Lightning devices, connect the Apple 8-pin cable* (2)
Press power button (5) to begin charging. Monitor charge status via screen icon on your
device.
To stop charging, remove cable from your device.
*Alternately, completely remove either cable (1 or 2) and connect your own USB charge cable
Tandem charging:
Connect your own USB/micro-USB cable (not
included) to Dual Cable Power Bank charge port (3)
Connect to any powered USB port. Use USB/AC
adapter (not included) for faster results
Connect electronic device(s) to either USB
port (1 or 2) on Dual Cable Power Bank using
attached cables or your own USB charge cable
Device(s) begin recharging — when fully charged,
Dual Cable Power Bank recharges
*Note: Dual Cable Power Bank LEDs remain lit while device is charging and show remaining
battery capacity. When device is full, Power Bank continues to safely trickle charge device. When
charge cable is removed, Power Bank shuts off in about 30 seconds.
*Note: Tandem charging requires a longer charging time
overall. For best results, tandem charge overnight.
Charge 10000 mAh Dual Cable
Power Bank:
Detach removable USB/micro-USB charge cable
(1) and connect to micro-USB IN port (3).
Connect/charge via any powered USB port. Use
USB/AC adapter (not included) for faster results.
Four LEDs (4) flash in 25% increments and remain
solid when corresponding capacity is reached.
*Note: For step 1, you may also use your own USB/
micro-USB charge cable (not included). LEDs may not
provide an accurate reading while battery is recharging. For
optimum performance, make sure all LEDs have stopped
flashing and remain solid to ensure full charge capacity.
Total recharge time (0% - 100%) = about 5-6 hours.
Parts Layout
3
Thank you for purchasing the RichardSolo 10000 mAh 2-Port Power Bank. Please read these instructions before operation
and save for future reference.
10000 mAh Dual Cable Power Bank
INSTRUCTION MANUAL
4
2 1
OUT1 - (5V 2.1A) + Removable
USB/micro-USB cable
OUT2 - (5V 2.1A) + Removable
USB/Apple Lightning 8-pin cable
IN - (5V 2.1A) Micro-USB input port
4 LED charge capacity indicators
(25%, 50%, 75%, 100%)
Power button
1
2
3
4
5
Check remaining
charge capacity:
Tap/release power button (5)
to check remaining power
bank charge capacity:
1 LED flashing = less
than 25%
• 1 LED solid = about 25%
• 2 LEDs = about 50%
• 3 LEDs = about 75%
• 4 LEDs = about 75-100%
Specifications:
Capacity: 10000 mAh
Cell Type: Li-polymer battery
Input: DC 5V 2.1A micro-USB
Port 1 Output: DC 5V 2.1A USB (w/removable
USB/micro-USB cable)
Port 2 Output: DC 5V 2.1A USB (w/removable
USB/Apple Lightning cable)
USB/micro-USB cable length: 5" (12.7 cm)
USB/Apple Lightning cable length: 5" — (12.7 cm)
Battery measures: 5.79" x 3.0" x 0.55"
(14.7 x 7.7 x 1.4 cm)
Weight: 8.15 oz. (231 g)
1
2
1
1
2
2
3
3
4
4
3
5
10000 mAh Dual Cable Power Bank
INSTRUCTION MANUAL
Continue
Safety Instructions
Read all instructions and warnings prior to using this product. Failure to read and follow these safety instructions could result in fire, explosion, electrical shock or
other hazard causing serious and/or fatal injury and/or property damage.
Do not modify, disassemble, open, drop, crush, puncture, or shred this
product
Do not expose this product to rain or water
Avoid excessive heat (open flame, sunlight, etc.)
Keep away from high voltage devices
Keep away from children
Maintenance:
Do not store in a depleted state — battery power cells
can be damaged
Charge Dual Cable Power Bank at least once per
month when not in use.
Keep unit dry — avoid damp conditions and corrosive
materials.
Do not clean with harsh chemicals, soaps or
detergents
1
2
3
4
5
1
2
3
4
Questions? Please email us at: RichardSoloHelp@gmail.com 2301 Kerner Blvd. Suite C, San Rafael, CA 94901 USA www.RichardSolo.com
USB Compatibility:
Port 1 (2.1A): with removable cable for
micro-USB devices
Port 2 (2.1A): with removable cable for Apple
Lightning 8-pin devices
*Note: For added versatility, remove a cable
and connect your own USB cable to either
port.
Package Contents:
10000 mAh Dual Cable
Li-polymer battery
• Instructions
/