Legrand 110 Punch Down Tool, Impact, IS-0282 Installation guide
- Category
- Cable assembly tools
- Type
- Installation guide
This manual is also suitable for
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
INSTRUCTION/INSTALLATION SHEET
110 PUNCH DOWN TOOL, IMPACT STYLE
IS-0282 REV. A
©Copyright 2008 by On-Q/Legrand All Rights Reserved.
11
0
Bi
t
Cutting Edge
Bit Holder
Bit Storage
Impact Indicator
R
e
l
ease
Di
a
l
Im
pact
A
djust
m
e
n
t
1. Introduction
P/N: 363293-01
110 Punch Down Tool, Impact Style
The impact tool is a spring-loaded tool used to terminate twisted pair cable on style 110 terminating blocks. The
spring-loaded mechanism assists in assuring the wire is properly seated on the contact. There is an impact
adjustment dial which can be turned from hi to low depending on application. Included with the tool is a 110
terminating bit. The bit has a terminating end and a terminating cut end. This gives the option to terminate and
connect a wire to series of contacts or just terminate and cut the wire to an individual contact.
2. ADJUSTING IMPACT SETTING
A. Turn impact adjustment dial so the arrow is pointing at the hi or low setting.
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 2 of 2
INSTRUCTION/INSTALLATION SHEET
110 PUNCH DOWN TOOL, IMPACT STYLE
IS-0282 REV. A
©Copyright 2008 by On-Q/Legrand All Rights Reserved.
3. INSERTING/REMOVING BIT
To insert bit:
A. Push and turn the bit into the bit holder until it slides into place.
B. Rotate the bit 90° clockwise until it locks into place.
To remove bit:
C. Reverse the previous steps.
4. BIT STORAGE
To insert bit into bit storage:
A. Hold the impact tool with the bit storage end facing up.
B. Insert the bit into the bit storage end as far as it will go.
C. Turn the release dial in a clockwise direction until the bit slides into place.
To remove bit from bit storage:
D. Hold the impact tool with the bit storage end facing down.
E. Turn the release dial in a counter clockwise direction until the bit falls out.
5. OPERATING INSTRUCTIONS
Style 110 Terminating Blocks:
A. Lay the wires in the wire slots.
B. Insert the 110 terminating bit into the impact tool and choose the correct end of the bit depending whether or not
the wire is to be cut off. (Illustrations show use of the cutting end)
C. Slide the bit into the wire slots and push down on the impact tool with the palm of your hand until it clicks.
D. Slide the bit out of the wire slots and make sure the wire is properly seated on the bottom of the wire slots. The
impact tool should ensure this is done right, but it is always a good idea to check.
Wire Slots
Terminated
and Trimmed
Cutting Edge
-
1
-
2
Legrand 110 Punch Down Tool, Impact, IS-0282 Installation guide
- Category
- Cable assembly tools
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Legrand 110 Punch Down Tool, Impact, IS-0282 Installation guide
-
-
-
-
-
-
-
-
-
