TECHNICAL DATA DIGEST
HARRIS TITANIUM ACRYLIC WALL PRIMER
PROCUCT DESCRIPTION: Harris Titanium Acrylic Wall Primer is an alkali
resistant surface conditioner in styrene acrylic base.
It provides a barrier coat for high pH surfaces. Seals
most surfaces preventing moisture migration.
Recommended as a primer coat for new concrete
surfaces, stucco, concrete block, mortar joint
surfaces, gypsum board and as a sealer for loose
chalk (in light condition) on previously painted
surfaces. This wall primer is also a sealer designed
to consolidate light chalk and concrete dust on the
surface, allowing a non-penetrating coating to
adhere properly. Retards efflorescence and
promotes good paint adhesion. Meets Federal
Specification TTP-001975.
SIZES: 1-gallon and 5-gallons containers
FINISH: 0-5% @ 60
o
Gloss
COLOR: White
TECHNICAL DATA
CONSISTENCY: 85 - 95 KU’S (KREBS-STORMER)
FLASH POINT: Non-Flammable
TOTAL SOLIDS (by weight): 56.00%
TOTAL SOLIDS (by volume): 39.00%
DRY FILM THICKNESS: 1.4 mils dry recommended
DRYING TIME: Set to touch between ten (10) to fifteen (15) minutes
@ 77
o
F and 50% R.H. Allow 1 hour to recoat.
TECHNICAL DATA (cont.)
PIGMENT (by weight): 41%
Titanium Dioxide: 15%
Silicas: 26%
VEHICLE (by weight): 59%
Water and additives: 31%
Acrylic Dispersion: 28%
APPLICATION
SURFACE Surfaces must be dry, clean and free of oil, grease,
PREPARATION: dirt and loose concrete.
NEW CONCRETE AND All surfaces must be dry and free of oil, dust, etc.,
PAINTED SURFACES: before painting. All surfaces previously coated with
cement base water paints, should be washed before
applying Titanium Acrylic Wall Primer. Can be
applied over light chalky surfaces.
THINNING: Not normally recommended, but if necessary, add
water up to half pint per gallon. Do not mix with
solvent or thinned paints.
MILDEWED Clean by scrubbing with water containing 16 oz.
SURFACES: household bleach and 2 oz. liquid detergent per
gallon of water. Then, follow procedure as for new
surfaces.
METHOD OF To insure complete mixing stir thoroughly. Apply
APPLICATION: uniformly with brush, roller or spray. Porous or
texture surfaces will require more primer. Avoid
application in direct sun or on hot surfaces.
COVERAGE: On smooth surfaces apply at a rate of approximately
350-400 sq. ft per gallon. Porous or texture
surfaces will require more primer.
CLEANUP: Wipe up drips and spatters with a wet cloth with
soap and water; clean equipment with soapy water.
PRECAUTIONS: Do not take internally. Close container after each
use. KEEP OUT OF THE REACH OF
CHILDREN!
-
1
-
2
