Page is loading ...
The following is the procedure for allowing units to communicate when
the number of Dip switches are not the same in the Remote and Receiver.
Dips in Handheld Remote:
If you cannot get this unit to work with your remote
please call us at 877-669-4669 and we will be happy to assist you.
Thank you for your purchase.
If you need assistance with this item
Please call WholesaleNow at 877-669-4669.
Dip Switch Locations
Typical DIP Switch configuration for remotes with 7 DIP Switches and Receiver with 4 Dip Switches.
Remotes with 8 dip switches:
Use the same configuration as the 7
switch models and set switch 8 to
ON (up).
Remote with 4 dip switches:
The dip switch positions need to
match. Confirm the switches on the
remote and receiver are set the
same.
1- on
2- off
3-6 match Receiver unit with four Dip switches
7- off
8- on ( only older units have 8 switches.)
Wire Harness Information
The wire harness on this unit may have a different
connector than older units and you will need to replace it
with the supplied wire harness.
Both wires on the new harness are black, older units may
have had a black wire and a wire with a white stripe.
The wires are not polarity based.
It doesn't matter which wire connects
to which terminal.
Connect the two (2) 1/4" female connectors to the TP/TH
and TH terminals on the control valve.
WholesaleNow.com
WholesaleNow.com
WholesaleNow.com
/
