Page is loading ...
NC
COM
GND
1
2
3
4
Two signal lines Two signal lines
voice box
The power cord The power cord
Warning sensor
socket
Moving detection and emails
Step 1: open the desk menu by right-click → main menu → set up → Alarm →
Motion
Step 2: enable the motion function
Step 3: set up the trigger, click the “settings”
Step 4: Click the email in “alarm” window and enable all channel “Snap”
Then click “OK” button to save settings.
Step 5: set the motion Area, click the settings
Step 6: choose the motion area you want, click and drag the mouse, the screen with
block is the motion area you want
Step 8: right- click → adjust Sensitivity ( remark: the number smaller, the sensitivity
higher) → click “save”
Step 9: click “Apply” bottom to save the motion settings
Step 10: click the “Exit” button into “setup” window
Step 11: click the “network” into network settings
Step 12: choose the email menu
Step 13: set the send email smtp server
Step 14: tick the SSL cheek
Step 15: set the send email address
Step 16: set the send email password
Step 17: set the receive email address
Step 18: click “Test”button for Test settings
Step 19: The test result will be displayed in warning window
Step 20: click “ok” bottom to exit
Step 21: click “exit “to exit network window
Remark: you will receive the alarm email if the motion alarm done
Email setting:
Please follow up the below link to set up the email notification:
https://support.zositech.com/hc/en-us/articles/115004611987-How-to-use-a-new-G
mail-account-to-set-DVR-mail-alarming-
How to add device (DVR) in ZOSI VIEW?
1. Open your ZOSI VIEW app, input your app's register name and app's register
password. Click “Login”.
NOTE: MAKE SURE THE CLOUD SERVER STATUS OF YOUR DVR IS
CONNECTED.
2. Click the“ ”in the topleft, select “Device Manager”.
Enter into “Device Manager”, click the“ ”in the top right.
3. Get into “Add Device”, input your device information (refer to the below picture).
After that, click the bottom of “Add Device”.
4. Then, click the“ ”in the top left, select the “Live Preview”.
Enter into “Real time monitoring”, click the “ ” in the top right.
In the interface of “Channel List”, select the device which you want to preview,
click the “ ”.
After that, the grey icon ( ) will change to colorful ( ), click the bottom of
“Start Live View”.
5. Finally just wait a little moment, you can view your DVR on your phone.
Wifi setting
Remark: Our DVR only can be compatible for RT3070 or RT5370 Wifi module as
picture:
Connection: Plug RT3070 or RT5370 Wifi module into the USB2.0 interface.
Operation Steps:
Step 1: open the desk menu by right-click → set up → Network
Step 2: choose the WIFI set up
Step 3: tick the “wifi enable”
Step 4: click the “Search signal” button to search wifi
Step 5: then input the wifi password you have searched
Step 6: click the “set up” button
Step 7: click the “Apply” button
Step 8: click the “exist” button to exist the window, it will be displayed in warning
window, click “ok” and back to the Main menu.
Step 9: when you finish all those steps , click the “information” button
Step 10: click the “network” button to check the Internet is OK.
/
