Trendnet TEW-503PI Quick Installation Guide

TEW-501PC

TEW-503PI

Version 10.12.2005

Lühike paigaldusjuhend

Page is loading ...

10

Troubleshooting

Q1:

A1:

Q2:

A2:

Q3:

A3:

I completed all the steps in the quick installation guide, but my card isn't

connecting to my access point. What should I do?

You should first verify that the Network card’s SSID matches your wireless

router or access point's SSID. If they already match, you should check your TCP/IP

properties to ensure that Obtain an IP address automatically is selected. Refer to

your Windows User's Manual if you are unable to locate your TCP/IP properties.

Windows is unable to recognize my hardware. What should I do?

Make sure your computer meets the minimum requirements as specified in

Section 1 of this quick installation guide. Also, you must install the wireless

configuration utility (as described in Section 2) BEFORE you physically install your

network card. Lastly, you may consider moving the card to a different PCI/PC Card

Slot.

I cannot open the wireless configuration utility. What should I do?

Go to your device manager (control panel > system) to make sure the adapter

is installed properly. If you see a networking device with a yellow question mark or

exclamation point, you will need to reinstall the device and/or the drivers.

If you still encounter problems, please refer to the User's Guide CD-ROM or contact

technical support.

Certifications

This equipment has been tested and found to comply with FCC and CE Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received.

Including interference that may cause undesired operation.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS

EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO

OPERATE THE EQUIPMENT.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause

undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

If this device is going to be operated in 5.15 ~ 5.25GHz frequency range, then it is

restricted in indoor environment only.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

TRENDware declares that TEW-501PC and TEW-503PI ( FCC ID: RYK-WL711A and

RYK-WL760A ) are limited in CH1~CH11 for 2.4 GHz by specified firmware controlled in

U.S.A.

12

@

Product Warranty Registration

Please take a moment to register your product online.

Go to TRENDnet’s website at http://www.TRENDNET.com

TRENDnet

3135 Kashiwa Street. Torrance, CA 90505

http://www.TRENDNET.com

TRENDnet Technical Support

Telephone:

Fax:

Email:

1(888) 777-1550

1(310) 626-6267

[email protected]

Tech Support Hours

7:30am - 6:00pm Pacific Standard Time

Monday - Friday

US/Canada Support Center European Support Center

Contact Contact

Tech Support Hours

Telephone

Fax:

Deutsch : +49 (0) 6331 / 268-460

Français : +49 (0) 6331 / 268-461

0800-907-161 (numéro vert)

Español : +49 (0) 6331 / 268-462

English : +49 (0) 6331 / 268-463

Italiano : +49 (0) 6331 / 268-464

Dutch : +49 (0) 6331 / 268-465

Eesti : +372-6593613 (9.00AM to 5:00PM)

+49 (0) 6331 / 268-466

8:00am - 6:00pm Middle European Time

Monday - Friday

Trendnet TEW-503PI Quick Installation Guide

Trendnet TEW-503PI Quick Installation Guide

in other languages

Related papers

Other documents