22-08-10 20:28Nikon F5 User Manual
Pagina 7 van 64http://www.scribd.com/doc/14852129/Nikon-F5-User-Manual
Remove camera body cap and front
and rear lens caps.
1
17
G-type Nikkor and other CPU Nikkor lens
• The G-type Nikkor lens has no aperture ring; aperture should be selected from
camera body. Unlike other CPU Nikkor lenses, aperture does not need to be set
to minimum (largest f-number).
• CPU Nikkor lenses other than G-type Nikkor lens have an aperture ring. Set the
lens aperture to its minimum and lock. When the lens is not set to its minimum
aperture setting and the power switch is turned on in Programmed Auto or
Shutter-Priority Auto exposure mode, blinks in the LCD panel and
viewfinder.
ƒEE
Minimum aperture:
Set lens to its minimum aperture when
using CPU Nikkor lens other than G-type.
The largest f-number of aperture on the
lens’ aperture index is the lens’ minimum
aperture.
• Aperture setting operations are performed
using the Sub-Command Dial on the
camera body. Do not move the lens’ aper-
ture once it is set to its minimum aperture.
• Aperture can also be set with the lens’
aperture ring in Aperture-Priority Auto or
Manual exposure mode when using CPU
Nikkor lens other than G-type. In this case,
aperture can only be verified through aper-
ture direct-readout.
• When G-type Nikkor lens is attached,
aperture does not need to be set to mini-
mum unlike other CPU Nikkor lenses with
aperture ring.
Push and hold lens release button and
turn lens clockwise.
Removing Lens
When lens is detached from
camera for a long time
Make sure to attach the supplied
body cap or optional body cap
BF-1A (BF-1 body cap cannot be
attached to the F5 camera body.)
.
18
3
INSTALLING BATTERIES
1Pull out and turn battery holder
release knob as shown. 2Remove battery holder MS-30.
19
Install eight AA-type batteries with
the “+” and “–” terminals positioned
as shown inside the holder.
4Return battery holder MS-30 to
battery chamber. 5Turn battery holder release knob
clockwise until it stops.
• To install Ni-MH Battery Unit MN-30,
follow steps 1-2 and 4-5.
Before installing batteries:
• Make sure the power switch is set
at OFF position.
• Use AA-type alkaline or lithium
batteries, or optional Ni-MH
Battery Unit MN-30 with the F5.
• When installing/replacing batteries,
always read “NOTES ON BATTER-
IES”, page 154.
CAUTION: When carrying the battery holder MS-30 removed from the camera
body, remove its batteries or install it in a case to avoid possible short-circuit
caused by contacts with other metal objects.