For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
PN621
AV IN WALL BOX INSTALLATION INSTRUCTIONS
Part Number(s): CMBBLWH, CMBBSWH
Wall cut-out Dimensions
CMBBLWH
AV IN WALL BOX, LARGE
CMBBSWH
AV IN WALL BOX, SMALL
Parts Included:
(1) - 1” X 5” CABLE BEZEL
(2) - RELEASABLE PUSH MOUNT
CABLE TIE
Tools Needed:
Tape Measure
Stud finder (“edge to edge” stud
finder recommended)
Drywall saw
Steel cutting tool (for Knock-Out
removal)
Mounting hardware (not included)
CMBBLWH
Back View
CMBBSWH
Back View
14.00”
14.00”
14.00”
7.25”
Page 1 of 3
Mounting
hardware
(not included)
16” on center
Wall Box placement instructions:
Locate desired placement location of the In
Wall Box. Using a stud finder, locate wall
studs. Cut hole between the wall studs using
drywall saw to the above dimensions for your
corresponding In Wall Box. Insert In Wall Box
and secure with appropriate mounting hard-
ware (not included).
Wall Studs spaced
Caution: Check for existing utilities or
other obstructions in desired placement
location prior to cutting hole.
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
PN621
Page 2 of 3
Cable Bezel installation
instructions:
Place Cable Bezel over cut-out.
Using downward pressure to
snap into place.
Cable Bezel
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
PN621
E-mail:
Fax:
(708) 444-6993
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 3 of 3
“D” Ring Installation
(CMBBCMR sold separately):
Insert push pins into the desired
hole location and engage the
push pins to secure to the In Wall
Box.
Knock-Out removal for
power:
Use cutting tool to cut the tabs
around desired knock-out you
want to remove. (ex. 3/4” or 1”
conduit or power outlet.)
Media Box Installation
(Using Bracket Kit CMBBRKT
sold separately):
Apply foam tape (supplied with
bracket kit) to the back of the
Media Box. Insert the Bracket
push pins into the desired loca-
tion and engage the push pins to
secure to the In Wall Box. Slide
Media Box into tak-tape and
tighten tak-tape around Media
Box.
“D” Ring
Knock-Out
Media Box
Foam Tape
CMBBRKT
-
1
-
2
-
3
Atlona CMBB Owner's manual
- Type
- Owner's manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Panduit N8522W Installation guide
-
Panduit S8512BA User manual
-
Panduit FMT1A Installation guide
-
Panduit Net-Contain Installation guide
-
-
-
-
-
-