2. Balboa
  3. Hand Held Jet

Balboa Hand Held Jet, Hand Held Jet For Magna Series Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Balboa Hand Held Jet Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
88-4046, Rev B June 17, 2009
HAND HELD JET FOR MAGNA SERIES INSTRUCTIONS
1. Turn off circulation pump.
2. Remove eyeball (#7) or flowpath (#8 or #9) from the jet by pulling on snout of eyeball or flowpath
spout. **It may be easier to remove therapy option with pump running and jet open. Block outlet
with index finger and pull on snout of eyeball (#7) or flowpath (#8 or #9).
3. Insert the adapter (#1) firmly into the jet. Rotate the adapter (#1) counterclockwise approximately
90
o
until it clicks. TO REMOVE THE ADAPTER (#1), turn it counterclockwise approximately 1/8 of a
turn or 45
o
and pull straight out.
4. The hole on the float (#3) must be above the water level to draw air.
5. Start the circulation pump.
6. Squeeze the trigger (#2) to start the hand held jet (#4) and release the trigger (#2) to stop it. If you
do not get water flow through the hand held jet, rotate the jet handle (#10) 90° to be sure jet is open.
TO CHANGE THERAPY OPTION IN HAND HELD JET:
Insert cage and eyeball (#5) (or flowpath #6) into hand held jet (#4) by pressing firmly to snap into place.
1. ADAPTER
2. TRIGGER
3. FLOAT
4. HAND HELD JET
5. CAGE & EYEBALL ASSEMBLY
6. DUAL PORT FLOWPATH
7. EYEBALL ASSEMBLY
8. DUAL PORT FLOWPATH ASSEMBLY
9. SINGLE PORT FLOWPATH ASSEMBLY
10. MAGNA SERIES JET HANDLE
/