Balboa Hand Held Jet User manual

HAND HELD JET FOR AFMKIl/FREEDOM SERIES & HAYWARD’S

JET AIR III

1. Turn off circulation pump.

2. Remove therapy option from the jet using the retaining ring wrench (#1) provided.

3. Insert the spacer (#2) into jet, then insert the adapter (#3) into jet and tighten it down with the

retaining ring wrench (#1).

4. Connect adapter (#3) and the end of the hose by lining up the tabs, pushing together and

turning counterclockwise to twist lock the two pieces together.

5. The hole in the center of the ﬂoat (#4) must be above the water level to draw air.

6. Start the circulation pump.

7. Squeeze the trigger (#5) to start the hand held jet (#6) and release the trigger (#5) to stop it.

TO CHANGE THERAPY OPTIONS IN THE HAND HELD JET:

TO INSTALL: Insert cage and eyeball (#7) (or ﬂowpath, #8) into hand held jet (#6) by pressing

ﬁrmly to snap into place.

TO REMOVE: Remove therapy option from the hand held jet (#6) by pulling on snout of eyeball or

ﬂowpath spout.

CONTACT YOUR RETAILER OR SPA MANUFACTURER FOR OTHER THERAPY OPTIONS.

88-4048 Rev A June 24, 2009

#1 10-5875 Retaining Ring Wrench

#2 30-5723 Spacer

#3 30-5722 Adapter

#4 36-5317 Float

#5 36-5314 Trigger

#6 36-5312 Hand Held Jet

#7 10-4826 Cage & Eyeball

#8 36-4811 Flowpath

This manual is also suitable for

Download PDF