2. Imbera
  3. 6071112 Series

Imbera 6071112 Series, 6361112 Series How-To Manual

  • Hello! I've reviewed the instructions on how to change the door opening direction for the Imbera coolers, including G319 series 5341211XXXXX, VR10 series 6071112XXXXX, and VR12 series 6361112XXXXX. The document details the steps to remove the grill, disconnect the wires, and reposition the door components. Ready to answer your questions about the process!
  • What is the first step to change the door opening direction?
    What kind of wires need to be disconnected?
    What tool is used to remove the safety pin?
HOW TO CHANGE THE DOOR OPENING DIRECTION?
This instructive applies for the series from:
G319 series 5341211XXXXX
VR10 series 6071112XXXXX
VR12 series 6361112XXXXX
1. Remove the front
grill.
2. Disconnect the
red and black wires
that come out of
the door.
1
2
RI-13-008 CHANGE THE DOOR OPENING DIRECTION _R0
5. Remove door from the
cooler and remove the
screws to take out the
bushing that is inside the
door frame.
5
3. Using a set of
pliers remove the
safety pin from the
selfclosing
cartridge.
4. Unscrew the 3 hex
head screws and
remove these, the
same with the star
washers.
3
4
6-7. Repeat the same operation by unscrewing and
remove the self-closing cartridge.
Switch plastic bushing to self-closing side and vice
versa.
8. Remove the top cap.
9. On the bottom insert the wires into the door
frame.
10.
Then
place
the
cap
into
cover
the
hole
67
10
HOW TO CHANGE THE DOOR OPENING DIRECTION?
10.
Then
place
the
cap
into
cover
the
hole
89
11 12
11. On self-closing side pull out the harness through
the hole.
12. Locate square washer on the closing mechanism of
the door and with the help of a 5/16”open
wrench, spin the washer 90ºdirection until the
mechanism locks.
RI-13-008 CHANGE THE DOOR OPENING DIRECTION _R0
HOW TO CHANGE THE DOOR OPENING DIRECTION?
13. Place the door at an
“open position” on the cooler,
first on the upper hinge, then
on the bottom one (make sure
the square washer remains on
final position).
14. Remove the top
cap to screw the
13
14
16
16. Pass the red and black wires through the tie and
close it, connect the wires with the same color.
cap to screw the
hinge in the
opposite side of
the cooler.
15. Cut the zip tie to unclip the
wires, these are located on
the right bottom side near
the evaporator.
14
15 17 17. It is important to place the
safety pin in the guide of
the auto-closing.
RI-13-008 CHANGE THE DOOR OPENING DIRECTION _R0
/