9
Manually adjusting the cooking time, consider time adjustment range and interval of selected programme, given in the table
of default settings.
For your convenience the cooking time range in all programmes starts with the minimum setting, enabling you to prolong the
operating time of the programme, if the dish is undercooked.
In certain automatic programmes countdown starts only when the device reaches its operating temperature. E.g. If you set the
enough steam. In the “PASTA” programme, the countdown begins after water starts boiling and the “Start” button is being re
-
pressed.
MASTERFRY function A5
The REDMOND RMK-M911E multikitchen is equipped with a raisable heating element. It allows you to use both the bowl
Be sure to use a thermal glove for gripping the tongs. Do not touch the heating disc regardless of the position it’s in!
For safety reasons use tongs when changing the position of the heating element (included in set).
To place the disc heating element into the lower position slightly lift it, so that its mounts exit slots on the walls of the
DO NOT try to change the position of the heating element if the appliance is plugged in!
DO NOT close the lid if the disc heating element is set to an upper position.
For cooking in the multikitchen use only frying pan, included in set.
Time Delay Function
consideration. The time of a delay should be longer than the cooking time of the selected programme; otherwise the programme
starts running right after you press “Start”.
When the automatic programme is selected and the temperature and cooking time are adjusted, you may set the “Time Delay”.
1.
blinking.
2. Press the “Hour” button repeatedly to adjust the hours in 24-hour format. Hold the button down to scroll through the
digits.
3. Press the “Min” button repeatedly to adjust the minutes. Hold the button down to scroll through the digits.
4. If you need to set a delay shorter than 1 hour, repeatedly press the “Hour” button to reset time to zero and adjust the
minutes using the “Min” button.
5. To cancel the settings press the “Reheat/Cancel” button and reset.
6.
When the time is set press and hold down the “Start” button. The Time Delay function indicator lights up. Set programme
starts running and the countdown begins.
7.
8. Press the “Reheat/Cancel” button to cancel the “Keep Warm”. The button indicator goes off.
The Time Delay function is available in all automatic programmes except “FRY”, “PASTA” and “QUICK COOK”.
It is not recommended to use the Time Delay function if dairy and other perishable products are being used (eggs, fresh milk,
meat, cheese etc.).
Setting the “Time Delay” in the “STEAM” programme remember that the countdown starts only when the device reaches its
operating temperature (water comes to a full boil).
Keep Warm Function
“Keep Warm” count up is being displayed. Press and hold down the “Reheat/Cancel” button to disable the function.
Disabling The “Keep Warm” In Advance
Reheat Function
REDMOND RMK-M911E can be used for warming up cold meals. To reheat cold meals:
•
• Close the lid until it clicks into place and plug in the unit.
• Press and hold down the “Reheat/Cancel” button for a few seconds until an audible signal is heared. Corresponding indi-
cators light up and the “reheating” process begins. The timer starts its countdown.
press and hold down the “Reheat/Cancel” button. Corresponding indicators go off.
The function may operate for a period of 24 hours, however, we recommend using it moderately, because a prolonged thermal
Standard Operating Procedure for Automatic Programmes
1. Measure the ingredients according to the recipe.
2.
Put them into the bowl. Make sure that all the ingredients including liquid are below the scale mark indicating maximum
3. Close the lid until it clicks into place. Plug in the unit.
4.
5. Use the “Hour” and “Min” buttons to adjust the time set by default for each programme.
6.
7. Press and hold down the “Start” button. The “Start” and “Reheat/Cancel” button indicators light up. Set programme starts
running and the countdown begins. Countdown of the “STEAM” programme begins only when water comes to a full boil,
repressed.
8.
9.
10. To interrupt cooking process at any stage, to cancel the set programme or the Keep Warm function press and hold down
the “Reheat/Cancel” button.
To achieve better cooking results, we recommend to refer to the cookbook provided. Each out of recipes has been adjusted for
this particular model.
If you did not achieve the desired result using automatic programmes, try versatile programme called “MULTICOOK”, featuring
a wide time and temperature adjustment range. This programme gives endless opportunities for new culinary experiments.
“MULTICOOK” Programme
This programme can be used to cook any meal with your personal time and temperature settings. REDMOND RMK-M911E,
featuring the “MULTICOOK” programme will be able to replace a big number of kitchen appliances. Now any recipe, either
from your family cookbook or Internet, can be adjusted for your multikitchen.
right after the programme starts running. The “Reheat/Cancel” button indicator lights up.
•
•
•
A big number of various dishes can be prepared with the help of “MULTICOOK”. Follow the recommendations of our chefs given
in the recipe book and the table of recommended temperature settings.