FM100FloatModule
GEARPULLERTOOL(MD#304800)
INSTRUCTIONS
215092 RevisionA Page3of3
Instructions
DANGER
Toavoidbodilyinjuryordeathfromunexpectedstart‐uporfallofraisedmachine,alwaysstopengine,remove
key,andengagesafetypropsbeforegoingunderheaderforanyreason.
TousetheGearPullerTool(MD#304800),followthesesteps:
1. Removecotterpinandcastlenutfrompump
output
shaft(D).
2. Lineupouterbolts(A)ongearpullerwithholesin
gear(B),andlineupcenter1/2in.bolt(C)with
outputshaft(D).
3. Hand‐tightenouterbolts(A)ongearpuller,making
suretheboltsgocompletelythroughthegear.
4. Tightencenter
1/2in.bolt(B)toremovegearfrom
shaft.Ifthegeardoesnotloosen,givethecenter
boltatapwithahammer.
NOTE:Thekeymayormaynotcomeoffwiththe
gear.DoNOTlosethekey.
©2019MacDonIndustries,Ltd.
Theinformation
inthispublicationisbasedontheinformationavailableandineffectatthetimeofprinting.
MacDonIndustries,Ltd.makesnorepresentationorwarrantyofanykind,whetherexpressedorimplied,with
respecttotheinformationinthispublication.MacDonIndustries,Ltd.reservestherighttomakechangesatany
timewithoutnotice.
Figure2:GearPullerTool
Figure3:GearPullerTool