Zebra ST6083 Owner's manual

Zebra
Brand
Zebra
Model
ST6083
Type
Owner's manual
Page 1 of 2 Part No. 1005977 Revision A
Installation Instruction for ST6083 Rubber Boot
1. Installation of the ST6083 Grey Rubber Boot for the Expansion Back.
STEP 1.
INSERT HANDHELD THROUGH
OPENING IN THE RUBBER BOOT
AS SHOWN IN FIGURE A.
Continued on other side…
Figure A
Figure B
STEP 2.
SECURELY FIT THE FRONT
END OF THE HANDHELD IN
THE END OF RUBBER BOOT.
SEE FIGURE B.
Page 2 of 2 Part No. 1005977 Revision A
STEP 4.
FIGURE E SHOWS THE
COMPLETED ASSEMBLY
OF THE RUBBER BOOT.
STEP 3.
FIRMLY PULL BOTTOM CORNERS OF RUBBER BOOT (ONE AT A TIME
WORKS BEST) AROUND THE END OF THE HANDHELD UNTIL SECURELY
ENCLOSED. AS SHOWN IN FIGURES C AND D.
Figure C
Figure E
Figure D
Appendix A: Support Services
Fortechnicalsupport,pleasevisittheSupportsectionofourcommunityIngenuityWorking:http://community.psion.com/support
.
  • Page 1 1
  • Page 2 2

Zebra ST6083 Owner's manual

Zebra
Brand
Zebra
Model
ST6083
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents