Hobie Livewell XL is a portable, electric livewell system designed for fishing kayaks. It features a 12-gallon tank with a built-in pump and can hold up to 88 lbs of water. The Livewell XL has two adjustable rod holders and can be mounted to the deck of your kayak. It also includes a battery, charger, and intake and drain tubes. With its adjustable tank level, you can customize the water volume to suit your needs.
Hobie Livewell XL is a portable, electric livewell system designed for fishing kayaks. It features a 12-gallon tank with a built-in pump and can hold up to 88 lbs of water. The Livewell XL has two adjustable rod holders and can be mounted to the deck of your kayak. It also includes a battery, charger, and intake and drain tubes. With its adjustable tank level, you can customize the water volume to suit your needs.
Livewell XL Manual
2 | Parts List
5
6
7
8
9
3
2
1
4
1. Livewell XL Tank Assembly
2. Rod Holders (2 additional)
3. Rod Holder Mounting Hardware
4. Intake Tube
5. Intake Ziptie
6. Drain Tube Level Clip
7. Charger
8. Battery
9. Pump Cap
Charging and Connecting Power | 3
hobiecat.com
Plug in your charger and
connect the charger cable
to battery. The battery will
take about 8-10 hours to
fully charge.
1
Remove the battery
cover and connect
the battery to the tank
connector
2
Replace the battery
cover and stretch the
Bungee ® over the lid.
3
Turn the switch ON to
test that the pump is
working
4
OnOff
4 | Intake Installation
Align the intake
connector with the tank
connector. Notice that
there is a small tab and
a large tab that need to
align.
1
Interlock the two tabs
and twist the connection
clockwise. NOTE: Tabs
are different sizes
2
Note: Small adjustment to the tube length and orientation need to be made
before going out on the water. Follow the instructions on page 6 for adjusting the
intake tube.
Plugging Into Boat | 5
hobiecat.com
Plug the Livewell intake
and drain tube into the
cargo scuppers.
1
Attach the tie-downs
to a nearby padeye and
tighten the straps.
2
Tandem Use Single Use
Note that the ProAngler 17T has two different plug-in locations for the Livewell
XL and may be arranged as shown below.
6 | Intake Tube Adjustment
Spin the clear tube on
the connector so the
opening on intake screen
faces forward towards
the bow of the boat.
1
Once you have the tube
rotated correctly, tighten
and trim the zip tie around
the connector and tube to
hold in place.
2
Perfect Too LongToo Short
Because every model is slightly different, you may have to make some
adjustments to the intake tube.
Bow
Tank Level Adjustment | 7
hobiecat.com
Remove the internal divider wall by flexing the outside edges of the wall and
freeing them from the buttons on the wall.
1
Attach the drain tube level clip over the middle hole if you want to fill the tank to
the maximum capacity.
2
Clip On:
Approx. 11 Gallons/ 41 L
88 lbs/40kg of water
Clip Off:
Approx. 6 Gallons/ 23 L
48lbs/22 kg of water
8 | Using the Tank
Turn the drain handle
clockwise aligning the tab
with the groove and push
down to engage the drain
tube.
1
Turn on the pump
2
The pump needs to be primed before water
flows into the Livewell. Propel the kayak
forward at 3 mph/ 5 kmph or faster. This
will force water up the intake tube, prime
the pump, and start filling the tank.
3
Filling the tank
Holding Water
If you want to conserve battery power or
just want to eliminate any water flow, you
can place the cap over the water inflow
tube after it is full to prevent the water
from draining out of the pump when the
switch is turned off.
Using the Tank | 9
hobiecat.com
The tube connected to the pump, protruding from the
wall, diverts and concentrates the flow of freshwater in
to the tank to create more current and circulation. This
will work well for most species of bait fish and fin fish.
The tube can be removed from the pump to reduce the
amount of current in the tank for smaller bait species.
Turn the pump off
1
Turn the drain tube counter-
clockwise and pull up to open
the drain. Once the drain is all
the way up, turn it slightly to the
left or right to hold the tube in
the up/open position.
2
Changing Water Circulation
Draining the Tank
Tank Care
Because the Livewell assembly contains electric components, use care storing it.
Proper maintenance is vital to keeping your Livewell working properly.
• Washing
Keeping your well and pump clean by washing it in fresh water and letting it dry.
This will help to prevent salt and mineral corrosion.
• Battery Care
When not in use, unplug the battery from the Livewell and keep it stored in a
dry place. If you are storing the battery for a long time, be sure to fully charge it
before storing. Recharge the battery for best care.
• Mildew and Odor Prevention
When storing, you should allow the inside of the Livewell to dry and keep the
hatch open to allow for airflow.
10 | Optional Rod Holder Installation
Possible rod holder locations for
ProAngler 12 & 14
Possible rod holder locations for
ProAngler 17T
Drill a 3/16” hole in the
pre-located dimples on
the tank
1
The Livewell XL comes with two pre-installed rod holders and two additional
rod holders for custom installation. More rod holders can be purchased and
installed.
Optional Rod Holder Installation | 11
hobiecat.com
Nut
Steel Washer
Rubber Washer
Install the mounting
screw into the rod
holder.
2
Thru-bolt the rod holder
to the tank so that the
nuts are tight. Do not
overtighten as it can
damage the rubber gasket.
3
PN 72020072
REV 141223
Hobie Cat Company
Holding Company
Oceanside, California, USA
1-800-HOBIE-49
hobiecat.com
Hobie Cat Australasia
Subsidiary
Huskisson, New South Wales, Australia
1-800-4-HOBIE
hobiecat.com.au
Hobie Cat Europe
Subsidiary
Toulon, France
+33 (0) 494 08 78 78
hobie-cat.net
Hobie Kayak Europe
Independent Distributor
Stellendam, The Netherlands
+31 (0) 187 499 440
hobie-kayak.com
Hobie Cat Brasil
Independent Distributor
Bahia, Brasil
+55 (73) 9982 2424
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Hobie Livewell XL is a portable, electric livewell system designed for fishing kayaks. It features a 12-gallon tank with a built-in pump and can hold up to 88 lbs of water. The Livewell XL has two adjustable rod holders and can be mounted to the deck of your kayak. It also includes a battery, charger, and intake and drain tubes. With its adjustable tank level, you can customize the water volume to suit your needs.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Hobie H-Bar User manual
-
-
-
-
-
-
-
-
-
Other documents
-
Ocean Kayak Scrambler 11 User manual
-
Ocean Kayak Boat 11 User manual
-
Boston Whaler 370 Outrage Owner's manual
-
PURSUIT 2003 Center Console-3070 Owner's manual
-
-
-
-
-
