2. Grizzly
  3. T20916

Grizzly T20916 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Grizzly T20916 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

MODEL T20916
ZERO-CLEARANCE TABLE
INSERT FOR G0690/G0691
INSTRUCTIONS
Important Considerations
CARBIDE BLADES:

DEDICATED INSERTS:


      

SPLITTER/RIVING KNIFE:     
        
       
       


DADO BLADE:     


      

Installing and Fitting Your Insert
1. 
2. 
 
Figure 1
• Disconnectsawfrompowerbeforefitting
orremovingtableinsert!
• Alwaysweareyeprotection.
• Donottiltthebladewhileitisintheinsert!
Forbeveledcuts,aseparateinsertmust
beusedwiththebladeslot(kerf)cutonly
atthatangle.
• Insert must be securely clamped down
with a board before plunging the blade
upthroughittocutthekerf.
• If using a blade stabilizer, check the
clearancebeforeraisingtheblade.
3.        
       



4.       
       
     
       
        



5. 

6.      

Figure 1.





CuttingtheBladeSlot(Kerf)
1.        




2. 

         
        

3. 
      
    




4. 
 

     
      
     

       


If you need help with your new insert, call our
Tech Support at: (570) 546-9663.
/