Designers Edge H-12000 User manual

Type
User manual

This manual is also suitable for

2 Year Warranty on Fixture
(Does not apply to bulbs, which have no warranty)
Congratulations and Thank You from The Designers Edge!
The xture you have purchased should give you years of trouble free
service. We take pride in the design and construction of each of our
products and work to maintain the quality of our materials and
craftsmanship to assure your satisfaction.
This product is warranted to be free of defects in workmanship and
materials for a period of 2 years from the original date of purchase.
If any problems appear (other than burnt out bulbs, which carry no
warranty) within 2 years, the purchaser may return the item, freight
prepaid, together with a copy of your original purchase receipt to:
The Designers Edge
11730 NE 12th Street
Bellevue, WA 98005
Upon receipt of the item prepaid with a letter describing the problem,
and a check for $7.50 to cover return postage and handling, the
company will, at its option, either repair or replace the defective part or
xture at no charge to the purchaser. This warranty does not apply to
xtures that have been used for rental or commercial purposes. It does
not cover xtures that have been altered in any way or xtures that have
been subject to misuse, accidents or damage in transit.
IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES. NO CHARGES WILL BE ACCEPTABLE FOR
UNAUTHORIZED REPAIRS, PARTS OR SERVICE.
Some states do not allow limitations on how long an implied warranty
lasts and do not allow exclusions or limitations of incidental damages,
so parts or all of this warranty limitations or exclusions may not apply to
you. Legal warranty rights will vary from state to state and you may have
other rights.
ENGLISH
IMPORTANT NOTICE:
Every attempt has been made to deliver a quality product that will give you years of trouble free service.
In the event that you have problems with the xture, please DO NOT RETURN TO PLACE OF PURCHASE.
PLEASE CALL THE NUMBER BELOW FOR BULB OR PARTS PROBLEMS:
(425) 637-9601
8-5 pm (West Coast time). All warranty problems are handled
directly through The Designers Edge.
www.designersedge.com
H-12000_inst.indd 2 5/20/08 9:37:08 AM
Safety Instructions
Please read all instructions carefully prior to using The Designers Edge
patio heater.
designed for indoor use only.
Check that your main supply voltage is the same as voltage indicated
on unit.
Disconnect power during installation and during lamp replacement.
Check mounting plate to make sure heater is securely fastened in
place.
CAUTION - The lamp is HOT. Make sure it is cool before replacing.
Keep out of reach of children. Lamp gets extremely hot during
operation.
Do not use an extension cord with heater. Do not let cord come in
contact with heater during operation.
For use on 15 amp circuit breaker only.
on and allow to cool before re-lamping.
ENGLISH
WARNING
Before using this heater read all warnings and instructions: LAMP GETS HOT!
ALLOW TO COOL BEFORE RE-LAMPING
H-12000_inst.indd 3 5/20/08 9:37:08 AM
Installation Notes
1. Disconnect power before installation and when re-lamping.
2. If you are unfamiliar with installing electrical xtures contact a qualied
electrician to install
3. Securely fasten mounting bracket to the xture.
4. Do not attempt to relocate xture when hot.
5. Minimum distance from side wall is 5’
6. Keep out of reach of children.
Lamp Replacement
1. Disconnect power supply and make sure lamp and xture are not hot.
2. Unscrew the screws at the top of the housing.
3. Open hinged cover, remove the lamp by pushing one end into it’s
holder and pulling the other end towards you.
WARNING: Do not handle lamp with your bare hands as the oil from
your hands will cause premature failure of the lamp.
CAUTION, before using this appliance:
Check that the voltage indicated on the type plate
corresponds to the mains supply voltage.
• Ensure that the heater has been securely fastened
in its nal mounting position.
• Unplug and turn o power switch during
installation, cleaning and/or replacing the
emitter. Always ensure that the emitter is cool.
• Do not handle the halogen heat emitter with
bare hands.
Do not use an extension cable with this product.
Keep the power cable away from the body of the heater as it will get hot
during use.
Ensure that children do not tamper with the heater.
Do not insert any object through any slot or opening in the heater.
ENGLISH
H-12000_inst.indd 4 5/20/08 9:37:08 AM
Use only on 15 ampere branch circuit.
Use with AC current only
Do not place objects such as furniture, papers, clothes and curtains closer
than 5 to the front of the heater and keep them away from the sides
and rear when the heater is plugged in.
Avoid the use of an extension cord because the extension cord may over
CAUTION: RISK OF FIRE
Keep combustible materials such as furniture,
paper, clothes and curtains at least 5’ (1.5m) from the
front of the heater and away from the sides and rear.
TABLE 1: SPECIFICATION
INSTALLATION
WARNING: This appliance MUST be grounded.
If the supply cord becomes damaged, it must be replaced by the manu-
hazard. Otherwise, the plug should be connected to a socket indoors.
MOUNTING
1. Securely fasten the heater to the bracket arm using the nut and
bolt supplied
2. Mount bracket backplate to mounting surface with 3 screws provided
3. Mount the heater on to the backplate by inserting bracket arm into backplate.
4. Insert locking pin to connect arm with backplate
ENGLISH
Minimum mounting
8’2”
Minimum mounting
distance from ceiling
1’ 5
7
/8
Minimum distance
from side wall when
ceiling mounted
5’
H-12000_inst.indd 5 5/20/08 9:37:08 AM
5. Insert screw into hole on top of bracket arm to secure
The heater must be mounted in such a way that the halogen emitter does not slant
more than 4˚ from the horizontal.
Plug power cord into wall socket
Turn on switch to operate
Allow the heater to cool before attempting to reposition or move. Never attempt
to move the heater while it is switched on.
surfaces when mounting.
ENGLISH
H-12000_inst.indd 6 5/20/08 9:37:16 AM
ENGLISH
Keep out of reach of children.
MAINTENANCE
In the event of heater failure please contact the retailer rst. For
spare parts and advice, please contact the manufacturer.
Disconnect the power before commencing any maintenance procedure including
cleaning.
To ensure optimal heat eectiveness, it is
recommended that after the heater has been
used approximately 80-100 hours, the front glass and the reector are wiped with
a lint-free cloth.
The heater is supplied with safety glass. In the
unlikely event that it should become cracked,
please contact the manufacturer for an immediate replacement.
REPLACING THE EMITTER
Turn xture o and unplug to ensure that the heat emitter is not illuminated
and that the heater body and emitter are cool.
• Unscrew the back two screws at the top of the casing.
• Open the hinged front cover.
• Remove the heat emitter from the spring loaded holders by pushing one end
further into its holder and pulling the end that is free towards you.
• Ret in reverse order.
CAUTION: Do not handle the heat emitter
with bare hands. Finger marks will burn into
the quartz emitter causing premature emitter failure.
H-12000_inst.indd 7 5/20/08 9:37:16 AM
ENGLISH
IMPORTANT INSTRUCTIONS:
When using electrical appliances, basic precautions should always be
including the following:
1) Read all instructions before using this heater.
2) This heater is hot when in use . To avoid burns, do not let bare skin
touch hot surfaces. Allow heater to cool before relamping or moving.
Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes and curtains at least 5 feet from the front of the heater and keep
them away from the sides and rear.
3) Extreme caution is necessary when any heater is used by or near
children or invalids and whenever the heater is left operating and unat-
tended.
4) Always unplug heater when not in use.
5) Do not operate any heater with a damaged cord or plug or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical or
mechanical adjustment, or repair.
6) For indoor use only
7) Never locate heater where it may fall into a bathtub or other water
container.
8) Do not run cord under carpeting. Do not cover cord with throw rugs,
where it will not be tripped over.
outlet.
10) Connect to properly grounded outlets only.
11) Do not insert or allow foreign objects to enter any ventilation or
the heater.
manner. Do not use on soft surfaces, like a bed, where openings may
become blocked.
H-12000_inst.indd 8 5/20/08 9:37:16 AM
13) A heater has Hot and arcing or sparking parts inside. Do not use it in
14) Use this heater only as described in this manual. Any other use not
injury to persons.
15) Avoid the use of an extension cord because the extension cord may
cord, the cord shall be no. 12 AWG minimum size and rated not less than
16) Disconnect xture from power source before relamping the xture.
1500 watts
SAVE THESE INSTRUCTIONS
This heater is for use on 120 volts. The cord has a plug as shown at A in
Figure 65.1. An adapter as shown at C is available for connecting three-
blade grounding-type plugs to two-slot receptacles. The green ground-
ing lug extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box. The adapter should not
be used if a three-slot grounded receptacle is available
ENGLISH
H-12000_inst.indd 9 5/20/08 9:37:18 AM
HEAT ZONE
MC
CHAUFFERETTE
USAGE
POUR PATIO
Modèle # H-12000
FRANÇAIS
H-12000_inst.indd 10 5/20/08 9:37:21 AM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25

Designers Edge H-12000 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI