Tait TMAC70 Installation guide

Brand: Tait

Model: TMAC70

Type: Installation guide

402-00042-00 www.taitworld.com

Tait accessories

TMAC70 Hand-Held Control Head

Installation Instructions

Introduction

The TMAC70 is a hand-held control head

for TM9100 radios that enables the user to operate

the radio at a distance from the radio body.

The hand-held control head plugs into one of the

RJ45 sockets on the TMAC34-1T remote control

head. The TMAC34-1T remote control head is

installed as part of the TMAA03-08 enhanced

remote kit.

A TMAA10-03 remote speaker (for 25W radios) or

TMAA10-06 remote speaker (for 40/50W radios)

is required when a hand-held control head is used.

Note: The hand-held control head cannot be used

with the TMAA03-25 remote kit.

Operation

The keys and controls work in the same way as those on the standard control head,

with the exception of the PTT and volume up and down keys. The hand-held

control head also has two additional function keys.

Turning the radio on

Press either the on/off key or the PTT key.

Turning the radio off

Press the on/off key for about half a second.

Adjusting the volume

Press the key to increase the speaker volume and

the key to decrease the volume.

Zone 11

Channel 12

Talkgr Menu

PTT key

on/off key

volume

2TMAC70 Hand-Held Control Head

Installation

Installation of the hand-held control head involves:

■Plugging the control-head cord into either

socket on the TMAC34-1T remote

control head.

■Installing the control-head mounting clip.

Installing the hand-held control head

Important:

The hand-held control head grommet must be installed whenever the control head

is plugged into the RJ45 socket. When installed, the grommet has two functions:

■to prevent damage to the control-head socket when there is movement of the

control-head cord, and

■to ensure that the control head is sealed against water, dust and other

environmental hazards.

1. Make sure the radio is turned off, then plug the control-head cord into either of the

RJ45 sockets on the TMAC34-1T remote control head.

2. Slide the control-head grommet along the control-head cord and push two adjacent

corners of the grommet into the control-head socket cavity.

3. Squeeze the grommet and push the remaining corners into

position.

4. Check that the grommet is seated correctly in the cavity.

Installing the mounting clip

Install the mounting clip in the most convenient location for the radio user. It must be within

easy reach of the user, but in such a position that the hand-held control head PTT key cannot

be inadvertently activated or jammed on.

Radio Programming

Note: The radio must be programmed with the hand-held control head installed.

1. Use the tool provided in the TMAC70 kit or an 8 mm AF

Allen key to remove the rear programming connector cover.

2. Connect a PC to the programming connector and use the

TM9100/TP9100 programming application to program

the radio.

3. Assign functions to Key 1 to Key 6 of the hand-held con-

trol head, if required (Function Ctrl Settings form).

Refer to the online help of the programming application for

more information.

More Information

Refer to your radio provider for more information about this product.

TMAC34-1T

TMAA10-03 or

remote speaker

TMAA10-06

TMAC70

Tait TMAC70 Installation guide

Tait TMAC70 Installation guide

Tait TMAC70 Installation guide

Related papers

Other documents