2. HySecurity
  3. EDSWG Keypad

HySecurity EDSWG Keypad Quick start guide

  • Hello! I've reviewed the Quick Start Guide for the HySecurity EDSWG/A Wireless Keypad. This guide provides instructions on how to program the keypad with NICE radio receivers, including the OXI/A and 318N models. It covers how to change codes, use the keypad with or without a code, and also has a caution about storing codes safely. I am ready to assist with any questions you might have regarding the document or the device.
  • What are the factory codes for the channel buttons?
    How do I transmit using the keypad?
    Can the same code be used for multiple channels?
    What do I do if I lose my codes?
1
MX4574 Rev. B ©2019 www.hysecurity.com • 800-321-9947
TECHNICAL BULLETIN
QUICK START GUIDE (MX4574)
The EDSWG Wireless Keypad will only work with NICE radio receivers.
FACTORY CODES:
Channel button A is 1 1
Channel button B is 2 2
Channel button C is 3 3
TRANSMITTING:
Press the code, then the channel button
*Example: 1 1 A will transmit on channel A
*Note: The same code can be programmed for each channel.
*Note: The keypad will transmit as long as the channel button is held down.
MODE 1 RECEIVER PROGRAMMING:
Mode 1 = Button A is receiver channel 1, button B is receiver channel 2 and button C is receiver channel 3
OXI/A Receiver:
i. Press and hold the Learn button on the OXI/A receiver until the light comes on solid and release
ii. On the keypad, press 1 1 and then hold A until the receiver light goes out
iii. Programming is complete for buttons A, B, and C
318N Receiver (only buttons A and B will function):
i. Press and release the Learn button on the 318N receiver
ii. Immediately after releasing the Learn button on the keypad, press 1 1 and then hold A until the receiver light goes out
iii. Release A and immediately press A again until the light on the receiver comes back on and ashes
iv. Programming is complete for all buttons A and B
CHANGING CODES:
Codes are congurable from 1 to 8 digits in length
CAUTION: STORE CODES IN A SAFE PLACE! It is not possible to reset keypad to default if codes are lost.
i. Press and hold 0 v. Press A
ii. While holding 0, press and release A vi. Press the new code
iii. Release 0 vii. Press A
iv. Press the exisiting code viii. Press the new code
ix. Press A
*Note: The same procedure is used to program all channel buttons
TO USE THE KEYPAD WITHOUT A CODE:
This allows the keypad to work as a simple entry/exit button with a single press of the channel button.
Deactivate code for channel A, B or C. Channel button A shown. Reactivate code for channel A, B or C. Channel button A shown.
i. Press and hold 0 i. Press and hold 0
ii. While holding 0, press and release A ii. While holding 0, press and release A
iii. Release 0 iii. Release 0
iv. Press the exisiting code iv. Press A
v. Press A v. Press your new code
vi. Press A vi. Press A
vii. Press A vii. Press your new code again
viii. Press A
QUICK START GUIDE:
EDSWG/A Keypad Programming for Nice Radio Receivers
/