Convotherm TDS 13 - Foam issuing from air vent User manual

Brand
Convotherm
Model
TDS 13 - Foam issuing from air vent
Type
User manual

Convotherm TDS 13 - Foam issuing from air vent helps to identify and fix issues related to foam emission from the air vent during the automatic cleaning process. It guides the user through necessary checks and provides step-by-step instructions for resolving the problem. The manual emphasizes the importance of using only approved cleaning agents and care products to ensure optimal performance. It also includes detailed procedures for software updates and checking software versions to ensure the device is running the latest and most effective software.

Convotherm TDS 13 - Foam issuing from air vent helps to identify and fix issues related to foam emission from the air vent during the automatic cleaning process. It guides the user through necessary checks and provides step-by-step instructions for resolving the problem. The manual emphasizes the importance of using only approved cleaning agents and care products to ensure optimal performance. It also includes detailed procedures for software updates and checking software versions to ensure the device is running the latest and most effective software.

Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
1/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
Foam issuing from air vent
General
These instructions are intended solely for an authorized customer service engineer.
Inform the customer of important points relating to operation and safety.
The problem
Despite adjusting the cleaning level to the actual degree of oven soiling:
Foam is issuing from the air vent during automatic cleaning (even for cleaning level 1);
Foam is coming out even though original CONVOTHERM cleaning agents are being used.
About this instruction manual
This instruction manual describes the steps to be taken to stop foam issuing from the air vent during
automatic cleaning.
Necessary additional instructions
These instructions are a supplement to the user and installation manuals and the servicing documen-
tation for your appliance and must only be used in conjunction with these documents. Please refer to
the manuals for technical data, intended use, design and operation and safety information.
Materials required
USB-stick
Requirements
Check that the following requirements have been met:
The USB stick containing the most recent software package update is available.
The combi steamer is ready for use.
Only cleaning agents and care products approved by Convotherm are being used.
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
2/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
Position of the dehumidifier valve
Item Name Function
1 Dehumidifier valve Fresh-air supply / low-pressure valve, overpressure valve
2 Vapour outlet Lets steam escape
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
3/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
Solution for easyDial appliances
1.
Check that the dehumidifier valve is working properly and
is not blocked by any foreign matter.
1.1
Switch on the combi steamer.
You will hear the dehumidifier valve being actuated three times
(mechanical sound).
2.
If you cannot hear any sound:
2.1
Open the Service program for Customer Services.
To do this, press and hold for 3 seconds all three buttons at
once for "Temperature", "Core temperature" and "Time".
2.2
Use the C-Dial to select diagnostic value d5.
2.3
Press the 'Time' button several times to actuate.
3.
Run a software update.
See the Training manual
4.
After switching the appliance off and back on again, check
that the software update installed successfully.
4.1
Open the Service program for Customer Services.
To do this, press and hold for 3 seconds all three buttons at
once for "Temperature", "Core temperature" and "Time".
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
4/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
4.2
Use the C-Dial to check the following read values:
4.2a
r41: SI-board version = 2.4.4 or above
4.2b
r43: easyDial version = 2.4.4A or above
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
5/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
4.2c
r71: Cleaning profile version = 1.9.2 or above (important!)
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
6/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
Solution for easyTouch appliances
1.
Check that the dehumidifier valve is working properly and
is not blocked by any foreign matter.
1.1
Switch on the combi steamer.
You will hear the dehumidifier valve being actuated three times
(mechanical sound).
2.
If you cannot hear any sound:
2.1
Press the 'Settings' button on the home page.
2.2
Press the 'Service' button on the 'Settings' page.
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
7/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
2.3
Enter (1) and confirm (2) the password for the Service menu.
2.4
Press the 'Dehumidifier valve' button on the I/O tab.
3.
Run a software update.
See the Training manual
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
8/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
4.
After switching the appliance off and back on again, check
that the software update installed successfully.
4.1
Press the 'Settings' button on the home page.
4.2
Press the 'General' button on the 'Settings' page.
Foam issuing from air vent
Convotherm 4 – TDS 13

Convotherm Elektrogeräte GmbH
Talstraße 35, 82436 Eglfing, Germany
T +49(0)88 47 67-0
F +49(0)88 47 414
www.convotherm.com
9/9
Part no. 9400141_02 version eng 12/18 Subject to changes
© 2018 Welbilt except where explicitly stated otherwise. All rights reserved.
4.3
Press the 'Appliance information' button on the 'General' page.
4.4
Check the following settings on the 'Appliance information'
page:
SIB software version = 2.4.4 or above
UI software version = 2.4.4A or above
Cleaning version = 1.9.2 or above
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Convotherm TDS 13 - Foam issuing from air vent User manual

Brand
Convotherm
Model
TDS 13 - Foam issuing from air vent
Type
User manual

Convotherm TDS 13 - Foam issuing from air vent helps to identify and fix issues related to foam emission from the air vent during the automatic cleaning process. It guides the user through necessary checks and provides step-by-step instructions for resolving the problem. The manual emphasizes the importance of using only approved cleaning agents and care products to ensure optimal performance. It also includes detailed procedures for software updates and checking software versions to ensure the device is running the latest and most effective software.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers