DV8 OFFROAD Billet Aluminum E-Brake Handle Cover Installation guide

Hello! I have reviewed the installation instructions for the E-Brake Cover JK. This document provides a step-by-step guide on how to correctly install the cover including how to position it and tighten the screws. I'm ready to help you with any questions you might have about the installation process or the device itself.
How many set screws are used?

Which direction should the single set screw face during installation?

What should be checked during the tightening process?

JEEP E-BRAKE COVER (JK)

INSTALLATION INSTRUCTIONS:

130 Cassia Way, Henderson, NV 89014 . 702.853.2060

JP-180009-BL

1. REMOVE TIRE TREAD AND CHECK TO MAKE SURE ALL 3 SET SCREWS ARE THREADED OUT.

SLIDE COVER OVER E-BRAKE HANDLE WITH SINGLE SET SCREW FACING DOWNWARD.

3. TIGHTEN UP SET SCREWS SLOWLY AND EVENLY. CONTINUOUSLY CHECK FUNCTION OF

E-BRAKE. IF SCREWS INSTALLED ARE TOO TIGHT, FUNCTION WILL BE AFFECTED. INSTALL TIRE

COVER ONCE FINISHED.

SET SCREW