5. Connect your microphone, other input audio sources, and output equipment to your Vortex

device. Refer to the Vortex User Guide for more information.

6. Configure your Vortex system using Conference Composer

TM

Instant

Designer

TM

software (refer

to the Vortex User Guide for more information). You will need to select the SoundStation VTX

1000 in

Instant

Designer. As

you complete the setup

has selected.

Copyright© 2004, Polycom Inc. All Rights Reserved. Polycom, the Polycom logo, and Vortex are registered trademarks and SoundStation VTX 1000, Conference Composer and

InstantDesigner are trademarks of Polycom, Inc. in the USA and various countries. All other trademarks are the property of their respective companies. Part #1725-07770-001

rev. C

Please refer to the respective User Guides for each product for warranty and support information.

SELECT, then scroll to VORTEX MODE and press SELECT.

Select VORTEX MODE ON, then press SAVE to save the

configuration.

Note: If your SoundStation VTX 1000 has been assigned a passcode, you will need to enter the passcode after you press

the MENU button. See your SoundStation VTX 1000 user guide for more information.

Connection of conferencing unit to

interface module

1. Using the supplied color coded (black connector) cable, connect the Auxiliary Output of the

Interface Module (D) to the desired input (such as Input B) of your Vortex Device (E).

2. Using the supplied color coded (white connector) cable, connect the desired output (such as

Output B) of the Vortex Device (F) to the Auxiliary Input of the Interface Module (D).

3. Connect the telephone line (B) to the Interface Module’s LINE input (D). If using a Vortex EF2241,

see connection options to the right.

C

D

E

F