MULTISPAN PIC-38 Owner's manual

Brand: MULTISPAN

Model: PIC-38

Type: Owner's manual

MULTISPAN PIC-38 is a process indicator with a 4-digit, 7-segment, 0.8” red LED display. It has a size of 48 X 96 X 65 mm and a panel cutout of 44 X 92 mm. The input range is 0-10V DC, 0-20mA DC, or 4-20mA DC, and the output is 1 relay, 1 C/O & 24V DC Transmitter. The selectable range is -999 to 9999. It has protection level (As per request) IP-65 (Front side) AS per IS/IEC 60529:2001. The operating temperature is 0°C to 55°C, and the relative humidity is up to 95% RH non-condensing.

The features of the MULT

PowerSupply

ProtectionLevel

Operating

Relative

(Asperrequest)

Temperature

Humidity

100to250VAC,50/60Hz,Approx4VA

IP-65(Frontside)ASperIS/IEC60529:2001

0°CTo55°C

Upto95%RHNonCondensing

Model

Display

Size(HXWXD)

PanelCutout

Input

Output

Range

PIC-38

48X96X65mm

44X92mm

4Digit7seg0.8”,redLEDDisplay

0-10VDC,0-20mADC,4-20mADC

1Relay1C/O&24VDCTransmitter

-999To9999Selectable

Working

Display

4DigitsDisplayinRedcolorindicatescurrentreadingofPV

1.Whenthepowerissuppliedtotheinstrumentthedisplaywillshowthepresent

PROCESSvalue.

2.TheRangecorrespondingto4to20mADCisselectablefromkeypad.

3.Thesensorwillprovide4to20mADCinputtothecontroller.Thedisplaywill

indicatetheProcessvalueaspertheselectableRangevalue.

4.IftheRangeissetto9999thenat4mADCinputthedisplaywillshow0and20mADC

thedisplaywillindicateselectedrange9999.

5.Ifyouselectloweralarmasamodetheninitiallyrelaywillremaininoncondition.

Whencurrenttemperatureequals(settemperature+HYST)relaywillbeturnoff.

Sotemperaturegoesdownandwhenittouchessettemperaturerelaywillagain

turnON.andthisprocesswillcontinuetoflow.

6.Ifyouselecthigheralarmtheninitiallyrelaywillbeinonconditionsotemperature

goesdownandwhenittouches(settemperature-HYST)valuerelaywillturnoffand

sotemperaturewillgohighandwhenitreachessetvaluerelaywillturnONandcycle

Continues.

7.IftheSLLvalueisbelow3.5mAthandisplayshowLow.

8.AndifSLLvalueisbetween3.5to4.00mA,DisplayShows‘00’.

9.WhentheinputexceedsthefullscaleRange(Approxabove1ADC)Displaywill

showOVER.

OPERATINGMANUAL

ProcessIndicator

PIC-38

Page-1

PIC-38 www.multispanindia.com

R1 R2 ENT

SET

PIC 38

1 2 3 4

Presskey

s E T

P A S S

1 2 3

0 0 0 0

H A L L A L In - b O t- B A B - L A B - O

0 0 0 0

H Y S

M O D E

Hystersis

Mode

Password

// / / /

(Range:1to1000Count)

USER CONFIGURATION

PowerON

Press



Press



&keytosetvalue



&keytosetmode



Press



Press



&keytosetvalue



&keytosetpassword



Presskey

Presskey

Presskey

Presskey

d p

I n p

0 0 0 0

Presskey

Input

Press



keytosetDecimalpoint



DecimalPoint

0-10VDC

0-20mADC

4-20mADC

0 - 1 0 0 - 2 0

4 - 2 0 Selectbykey

L R N G

H r n g

0 0 0 0

Presskey

Press



&keytosetlowrange



Press



&keytosethighrange



LowRange

HighRange

Page-2

PIC-38 www.multispanindia.com

f L T R

O F S T

C R F C

0 0 0 0

s L L

A 3.5

Presskey

Press



Press



&keytosetfiltertime



&keytosetoffsetcount



Press



Press



(Ifselect4-20mA)

&keytocorrectionfactor



&keytosetsignallowlavel



Filtertime

Offset

CorrectionFactor

SignalLowLevel

(range:±100counts)

(range:0.1secto10.0sec)

(range:±999counts)

PresskeyforSave&Exit

ConnectionDiagram

Page-3

PIC-38 www.multispanindia.com

+ +

12 3 4 5 6 7 8 9 10

0/4-20

mA DC

24V DC

NO C

O/P

0-10V

Range:

-999 To 9999

I/P:

0-10V DC

4-20mA DC

0-20mA DC

50/60 Hz

4VA

100

250V AC

MadeinIndia

www.multispanindia.com

Product improvement and upgrade is a constant procedure. So for more updated operating information and support,

Please contact our helpline : +91-9978991474/76/82 or Email at [email protected] Ver: 04-2017

Allsafetyrelatedcodifications,symbolsandinstructionsthatappearinthisoperatingmanual

orontheequipmentmustbestrictlyfollowedtoensurethesafetyoftheoperatingpersonnelas

wellastheinstrument.

Ifalltheequipmentisnothandledinamannerspecifiedbythemanufacturer,itmightimpairthe

protectionprovidedbytheequipment.

=> Readcompleteinstructionspriortoinstallationandoperationoftheunit.

WARNING : Riskofelectricshock.

3) Cable used for connection to power source, must have a cross section of 1mm or greater. These wires

should have insulations capacity made of at least 1.5kV.

2) To reduce electro magnetic interference, use wire with adequate rating and twists of the same of equal size shall

be made with shortest connection.

1) To prevent the risk of electric shock power supply to the equipment must be kept OFF while doing the wiring

arrangement. Do not touch the terminals while power is being supplied.

4) A better anti-noise effect can be expected by using standard power supply cable for the instrument.

1) This equipment, being built-in-type, normally becomes a part of main control panel and such in case the

terminals do not remain accessible to the end user after installation and internal wiring.

2) Do not allow pieces of metal, wire clippings, or fine metallic fillings from installation to enter the product

or else it may lead to a safety hazard that may in turn endanger life or cause electrical shock to the operator.

3) Circuit breaker or mains switch must be installed between power source and supply terminal to

facilitate power ‘ON’ or ‘OFF’ function. However this mains switch or circuit breaker must be

installed at convenient place normally accessible to the operator.

4) Use and store the instrument within the specified ambient temperature and humidity ranges as

mentioned in this manual.

WarningGuidelines

SafetyPrecautions

Installation Guidelines

Maintenance

1) Prepare the panel cutout with proper dimensions as show above.

2) Fit the unit into the panel with the help of clamp given.

3) The equipment in its installed state must not come in close proximity to any heating source,

caustic vapors, oils steam, or other unwanted process by products.

4) Use the specified size of crimp terminal (M3.5 screws) to wire the terminal block. Tightening the

screws on the terminal block using the tightening torque of the range of 1.2 N.m.

5) Do not connect anything to unused terminals.

1) The equipment should be cleaned regularly to avoid blockage of ventilating parts.

2) Clean the equipment with a clean soft cloth. Do not use isopropyl alcohol or any other cleaning agent.

3) Fusible resistor must not be replaced by operator.

Mechanical Installation

136mm - 5.35 inches

60mm - 2.36 inches

MODEL A

48mm 96mm 44mm 92mm 4.5mm 66mm

D E

DIMENSIONS

PIC 38

SET

R1 R2

ENT

1 2 3 4

Page-4

PIC-38 www.multispanindia.com

MULTISPAN PIC-38 Owner's manual

Brand: MULTISPAN

Model: PIC-38

Type: Owner's manual

The features of the MULT

Download PDF

report

MULTISPAN PIC-38 Owner's manual

MULTISPAN PIC-38 Owner's manual

Related papers

Other documents