Lumination Tela Mini Series Hexcel Louver Accessory Installation guide
- Type
- Installation guide
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 2
(Rev 06/05/23)
IND437-Lumination-Tela-Mini-Hexcel-Louver-Accessory-Installation-Instructions_R01
Installation Guide
IND437
Lumination® Tela Mini
Hexcel Louver Accessory
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT SAFETY
INSTRUCTIONS
When installing or using this track system, basic safety
precautions should always be followed, including the
following:
a. Read all instructions
b. Do not install this track in damp or wet locations.
c. Do not cut any track sections.
d. Do not install any part of a track system less than 5
feet above the oor.
e. Do not install any luminaire assembly closer than
6 inches from any curtain, or similar combustible
material.
f. Disconnect electrical power before adding to or
changing the conguration of the track.
g. Do not attempt to energize anything other than
lighting track luminaires on the track. To reduce the
risk of re and electric shock, do not attempt to
connect power tools, extension cords, appliances, and
the like to the track.
h. Do not connect a track to more than one branch
circuit unless the track is constructed so that it can be
used with more than one branch circuit. Check with
a qualied electrician. Although the track lighting
system may seem to operate acceptably, a dangerous
overload of the neutral may occur and result in a risk
of re.
SAVE THESE INSTRUCTIONS
For future reference when adding xtures
or changing the track conguration.
FOR USE WITH CEILING MOUNTED TRACK ONLY.
READ TRACK MANUFACTURER’S INSTALLATION
INSTRUCTIONS FOR GUIDELINES ON TRACK
INSTALLATION.
SKU
Material
Description
Product
Description
93026696 LTMHX LTM HEXCEL LOUVER
WARNING
RISK OF ELECTRIC SHOCK
Turn power o before inspection, installation or removal.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 2
(Rev 06/05/23)
IND437-Lumination-Tela-Mini-Hexcel-Louver-Accessory-Installation-Instructions_R01
Lumination® Tela Mini Installation Guide
Installation of Hexcel Louver on the Tela Mini Series Track Light
Place the hexcel louver inside the
accessory ring, so that it sits evenly
inside the ring. If the LTM xture is
equipped with Whiter White, the
glass lens should sit on top of the
louver.
Place the accessory ring back inside
the cap with the louver outermost
in the assembly.
Begin with xture disconnected
from the track.
Unscrew the top of the xture and remove the cap and black plastic accessory
ring.
Accessory ring
Hexcel louver
Glass
(if equipped)
Cap
Screw the cap back onto the xture.
1
543
2
Accessory ring
Cap
-
1
-
2
Lumination Tela Mini Series Hexcel Louver Accessory Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Lumination LTC Series Hexcel Louver Accessory Installation guide
-
-
-
-
-
-
-
-
-
Other documents
-
GE Appliances IND435 Installation guide
-
Cooper Lighting 641 Series User manual
-
-
-
-
-
-
-
-