standivarius Solo X User manual

Wireless Mouse only

1. Remove USB receiver from underside of mouse.

2. Insert receiver into available laptop USB socket.

3. Insert AA disposable or re-chargeable battery into compartment

with polarity as indicated and replace cover.

4. Your mouse is now connected.

As part of solo X / solo #pad wireless keyboard / mouse combo

1. Remove USB receiver from underside of mouse and save for use

later if you lose the unifying USB receiver.

2. Obtain the unifying USB receiver from the keyboard tilt-strip

accessory.

3. Insert receiver into available laptop USB socket.

4. Switch on keyboard using the switch on the right-hand edge.

5. If the blue LED ﬂashes press the Esc and K keys simultaneously

and then release.

6. Insert one AA disposable or rechargeable battery into mouse battery compartment with polarity

as indicated and replace cover.

7. Your keyboard and mouse are now connected.

Note:

If you lose the unifying mouse, then switch oﬀ keyboard, and remove mouse battery.

Obtain original USB receiver supplied with mouse and insert into laptop and repeat steps 3 to 7.

Auto power-save

These features will deactivate mouse and keyboard when not in use and removing the USB

receiver from your laptop will turn oﬀ the mouse and keyboard for transportation.

solo X / solo #pad wireless combo pairing instructions

standivarius

DMR Ergonomics SRL

Calea Circumvalatiuniinr 37 / 27

300671 Timisoara

Romania

UK: [email protected] / ++ 44 115 647 7406

Northern Europe (SE, FI, DK, NO) [email protected] / ++46 10 551 6270

Benelux (B, NL, L): [email protected] / ++40 723 014912

DACH (D, A, CH): [email protected] / ++40 728 160023

Other: oﬃce@standivarius.com / ++40 728 160023