2. HELY WEBER
  3. 4849-SHORT

HELY WEBER 4849-SHORT User manual

  • Hello! I've reviewed the user manual for the Hely & Weber hand brace, including models 4849-SHORT, 4849-LONG, and XTender. The manual provides clear application instructions, focusing on proper fitting and safety precautions. I understand the device has moldable tabs and adjustable straps. Feel free to ask any questions about its application or care.
  • What should I do if I experience swelling, pain, or skin irritation?
    How should I clean the hand brace?
    What is the first application step?
Rev D 4/23
XTender™
4849-SHORT
4849-LONG
Warnings and Instructions: Review carefully, proper applicat ion is required
YWarning: This device will not prevent or eliminate risk of injury. Do Not Overtighten. If swelling, pain, skin
irritation, or an unusual reaction occurs, discontinue use immediately and consult your medical professional.
Care: Hand wash using mild soap. Rinse thoroughly. Air dry only. Do not tumble dry.
© 2023 Weber Orthopedics Inc. DBA
Hely & Weber all rights reserved
1185 E Main St., Santa Paula, California 93060
California: 800-221-5465, National: 800-654-3241
International: 805-525-4244, fax: 805-933-2348
U.S. fax: 800-559-5975, www.hely-weber.com
1
1. Remove straps. Mold proximal tab to create a
dorsal hand cuff.
(shown for right hand application)
2
2. Bend moldable nger area to the desired
position.
3
3. Place brace on at surface. Align hand in
brace. Attach long strap at cuff. Pull across
wrist and fasten.
4
4. Attach one of short straps, pull and fasten
across knuckles.
5
5. Attach other short strap, pull and fasten across
ngers.
6
6. Finished application.
Scan for Video
Rev D 4/23
XTender™
4849-SHORT
4849-LONG
Warnings and Instructions: Review carefully, proper applicat ion is required
YWarning: This device will not prevent or eliminate risk of injury. Do Not Overtighten. If swelling, pain, skin
irritation, or an unusual reaction occurs, discontinue use immediately and consult your medical professional.
Care: Hand wash using mild soap. Rinse thoroughly. Air dry only. Do not tumble dry.
© 2023 Weber Orthopedics Inc. DBA
Hely & Weber all rights reserved
1185 E Main St., Santa Paula, California 93060
California: 800-221-5465, National: 800-654-3241
International: 805-525-4244, fax: 805-933-2348
U.S. fax: 800-559-5975, www.hely-weber.com
1
1. Remove straps. Mold proximal tab to create a
dorsal hand cuff.
(shown for right hand application)
2
2. Bend moldable nger area to the desired
position.
3
3. Place brace on at surface. Align hand in
brace. Attach long strap at cuff. Pull across
wrist and fasten.
4
4. Attach one of short straps, pull and fasten
across knuckles.
5
5. Attach other short strap, pull and fasten across
ngers.
6
6. Finished application.
Scan for Video
/