ADM-P600 Page 1 of 4
A
D
E
F
G
B
C
70mm
(2.76”)
600mm (23.62”)
30mm
(1.18”)
40mm (1.57”)
136mm
(5.35”)
160mm
(6.30”)
COMPONENT CHECKLIST PRODUCT DIMENSIONS
Item Name QTY
A Post, 600mm Tall 1
B Cable Cover 1
C Plastic Slot Insert 4
D Connector Bar 4
E M6 x 8mm Grub Screw 8
F M6 x 10mm Hex Bolt 8
G 3mm Hex Key 1
REqUIRED TOOLS
FOR INSTALLATION
10mm
Spanner
Installation Guide
ADM-P600
Post 600
ADM-P600 Page 2 of 4
INSTALLATION INSTRUCTION
Step 1.
Step 2.
Insert the connector bars (part D) halfway
into the non-threaded end of the lower post.
The two connector bars with grub screws
(part E) go in the front of the column and
the 2 connector bars with hex bolts (part F)
go in the back.
Join the posts together by sliding the
600mm column (part A) onto the connector
bars (part D).
Hex Bolts (part F) to be flush with the surface
D
E
F
D
Back of Post
D
F
A
The two connector bars
with hex bolts (part F)
in the rear of the post.
Front of Post
A
1800mm/
600mm
Post
D
E
The two connector bars
with grub screws (part E)
in the front of the post.
! IMPORTANT
Connector bars should be inserted into
the non-threaded end of the column.
ADM-P600 Page 3 of 4
Step 3.
Step 4.
Tighten all grub screws (part E) on the
front of the column using the hex key
(part G). On rear of column tighten hex
bolts (part F) by hand. Finish tightening
using a 10mm spanner.
Add an Atdec base to the threaded end of the column
Add cable cover (part B) and
plastic slot inserts (part C) after
installation is complete.
10mm
Spanner
D
E
F
ADM-B
ADM-B
with ADM-C
Threaded
End
Threaded
End
ADM-FP
Threaded
End
Threaded
End
ADM-FS
C
A
B
ADM-P600 Page 4 of 4
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. ©20171211A
atdec.com
/
