Brodit 834703 Datasheet

Product 834703

834703 ProClip

Console mount

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320288347035

Item no 834703 fits:

Land Rover Range Rover Evoque 12 (For all countries)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before attaching the ProClip.

1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the

enclosed gap opener into the gap between the center console panel frame and the console edge, to widen the

gap. Peel off the cover of adhesive tape on the ProClip. Press the angled edge on the left side of the ProClip into

the gap next to the gap opener. Pull out the gap opener.

2. Push firmly on the right side of the ProClip so it flexes downward and hooks around the console sidewall edge.

Press forward on the lower side of the ProClip to make sure the angled edge is hooked all way around the

console edge.

3. This ProClip fits on the right and left side of the center floor console. You can also use one on each side.

4. The ProClip is in place.

2(2)

Download PDF