Digi Connect WAN 3G IA Quick start guide

Category
Serial servers
Type
Quick start guide
1
© Digi International, Inc, 2010
Digi, Digi International, Inc., Digi Connect and the Digi logo are trademarks or registered trademarks of Digi International, Inc., in the United States and other countries worldwide. All other trademarks are property of their respective owners.
3
a
b
2
4
Quick Start Guide
Digi Connect
WAN 3G
CDMA provisioning
a
b
a
b
+
-
WAN 3G IA
models (not included)
Verify kit contents
Congure your cellular settings
Validate Internet connection
Digi Connect WAN 3G
- may be sold
separately
Power supply
Open your web browser and enter the IP address 192.168.1.1 in the URL address bar
From the web interface, under Conguration, click Mobile. Enter your service provider name and connection parameters and click Apply. For CDMA carriers
that support Over-the-Air provisioning, select Click Here to automatically provision the device, then click Apply.
Your device is now congured. If you would like to verify your connections go to step 5
NOTE:
If you have diculty discovering your device, make sure your host computer is set up to obtain IP addresses automatically (DHCP server is enabled by default on the
device). Also ensure the rewall software is temporarily disabled
Disconnect the Ethernet cross-over cable and reconnect it. This will re-establish the Ethernet connection by assigning a new IP address through the DHCP server
To verify your Internet connection, enter a website of your choice (e.g. www.digi.com) in the URL address bar of your browser and click enter. Connecting to a
website indicates the connection is working
For additional information about your cellular connection click System Information > Mobile or reference the Users Guide provided on the Digi support site
(www.digi.com/support/)
Ethernet
cross-over cable
(not included with Connect
WAN 3G IA kit)
External power supply for
Connect
a
Connect cellular antennas
b
Connect Ethernet cross-over cabke to a PC and the
Ethernet port located directly next to the power jack
c
Connect power supply
c
a
b
a
or
Connect hardware
Cellular
Antennas
90000869_D
DB9
1
2
3
4
5
6
7
8
9
RS232
DCD
RxD
TxD
DTR
GND
DSR
RTS
CTS
RI
RS422/485
Full Duplex
CTS-
RxD+
TxD+
DTR
GND
RxD-
RTS+
CTS+
TxD-
RS485
Half Duplex
not used
RxD+
TxD+
not used
GND
RxD-
not used
not used
TxD-
DB9 Serial Pinout
NOTE: Set serial mode in software then on the
web interface go to Conguration/Serial Ports
Digi Connect
WAN 3G IA
  • Page 1 1

Digi Connect WAN 3G IA Quick start guide

Category
Serial servers
Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI