GB
Follow the instructions on the display
Displays
Remove the protective film, if present,
from the display.
Once the desired setting appears
on the display it can be confirmed
pressing the “OK” button and
the next step in the programming
can be carried out.
If the “<<“ cancel
button is pressed the
operation set is cancelled
and the previous screen is
restored.
The “-/+” browser knob has
different uses, depending on the
function chosen:
• For browsing through the
menus and the submenus
• For increasing/reducing the
indicated values
• For browsing through the
cooking functions
• For selecting the Turbogrill
option
• For increasing/reducing the
cooking time and temperature
• For browsing through the
memories
The Function knob is used to select the various oven functions. Each click
of the knob corresponds to a function:
Turn the
F
knob two clicks to
the left.
The message SETTINGS
APPEARS ON THE DISPLAY
Auto Recipes
Setting (set)
Special functions
F
-/+
If the display shows the message
“Demo Mode in progress”
, the
heating elements of the cavity are disconnected.
To exit the “Demo” mode and restore normal oven operation,
proceed as follows:
1. Disconnect the oven from the mains and reconnect it within 60
seconds:
2. turn the Functions knob to the “Lamp” position
3. press the “<<” button,
4. turn the Functions knob to the “0” - Stand by position,
5. Press the “OK” button.
To enter the “Demo” sequence, proceed in the same manner.
Child Safety with control panel lock
To activate or deactivate the “Child Safety Lock” press simultaneously
on the “<<“ and “OK” buttons for 5 seconds. If activated, the
functions of the knobs and the buttons are locked and the display
shows the
Request for confirmation when the settings are changed
If the Function knob is turned during a cooking cycle, the oven asks you
to confirm this choice so as to avoid accidental changes to the cooking
cycle settings.
If the knob is turned back to its original position the display will show
the settings for the cooking cycle being performed.
In any case, the oven continues with the cooking cycle until the user
confirms the change in settings.
AUTO OFF device
For safety reasons, the oven switches off automatically (except for the
Special function) after 4.5 hours of continuous operation.
To save energy in Stand By mode, press button “<<“ to deactivate
the display (display in OFF mode). To switch the display back on, press
the button “<<“ again.
To change a language that has been set mistakenly, proceed as follows:
1. Turn the Function knob to the “SETTINGS” position, turn to
Language and confirm by pressing the “OK” button.
2. Reselect the desired language using the “-/+” knob and confirm
pressing the “OK” button.
Description of control panel
Demo Mode
Safety Features
SETTINGS
Turn the knob two clicks to the left. The following message appears
on the display:
Reset brightness and
contrast settings
Set the Function
knob to OFF
Turn the Function
knob to settings
Press and hold “OK”
for 5 seconds.
Original factory
settings will be
restored.
* factory setting
language:
ENGLISH*
DEUTSCH
FRANCAIS
ITALIANO
ESPAÑOL
PORTUGUES
NEDERLANDS
SVENSKA
NORSK
DANSK
SUOMI
Restoring a language
Using the appliance for the first time
Setting the clock
The clock appears on the display.
Highlight the desired time using the “-/+” knob and
confirm your choice pressing the “OK” button”.