AMX PS-POE-AF Installation guide

Brand: AMX

Model: PS-POE-AF

Category: PoE adapters

Type: Installation guide

Installation Guide

PS-POE-AF PoE Injector

Overview

The PS-POE-AF (FG423-80) is a Power-over-Ethernet (PoE) power supply

with integral DC Injector (FIG. 1). It provides DC power for one PoE-

equipped device by "Injecting" DC power through the CAT5 ethernet cable.

The PS-POE-AF supports the IEEE standard PoE pinout:

Pins 4&5 Power (+) / Pins 7&8 Power (-). See Pin Connections (on reverse)

for details.

Key features include:

• Power over Ethernet (PoE)

• 10/100/1000 (MbPS) Data Rates

• Self-contained Injector

• 100-240VAC Universal Input

• Desktop Style / Non-vented Case

• IEEE802.3af Compliant Detection, Disconnect, Overload and Over

Voltage Control Function

• Load Diagnostic LED

• UNH IOL Test Report

• Over Load Shutdown and Short Circuit Protection

• Regulated Output With Low Ripple

• Meets Safety Agency Requirements

• Complies with EMI/RFI Regulations

Product Specifications

FIG. 1 PS-POE-AF Power-Over-Ethernet Power Supply

PS-POE-AF Specifications

Input Specifications

AC Input Voltage Range 100-240VAC -10%, +6%

Line Frequency 47-63Hz

AC Input Current 0.6A MAX at 90 VAC + Full Load

Protection • Internal Primary Current Fuse

• Inrush Limiting

Input Power Cord 50 mm IEC power cord terminated with a

grounded Edison plug for AC input

PS-POE-AF Specifications (Cont.)

Output Specifications

Output Voltage 48 VDC Nominal

Output Current 0.3125 A Max

Combined Line and

Load Voltage Regulation

Excluding Cord ±1%

Ripple and Noise 1% Vp-p Max

Transient Response • 0.5ms for 50%

• Load Change Typical

Protection • Foldback Overcurrent Protection

• Short Circuit Protection

Power Indicator LED indicates the presence of DC on the

output

General Specifications

Topology • Switching-Fixed

• Frequency Flyback

Dielectric Withstand • Primary-Secondary 3000VAC, 4250VDC

• Secondary-Ground 500VDC

Spacing 5mm Primary-Secondary

Leakage Current Less than 250 uA

Efficiency • 65% Typical @ Max. Load

• 120VAC/60 Hz

Weight (excluding cord) 7 oz (200 g)

Dimension (HWD) • 5 1/4" x 2 1/8" x 1 7/16"

• 13.3 cm x 5.4 cm x 3.6 cm

Case Material Black 94V0 Polycarbonate

Cord and Connectors Dual RJ45 jacks built into the enclosure

EMC Information

FCC • Part 15 Class B

• EN55022 Class B

Immunity ESD: EN61000-4-2

RS EN61000-4-3

EFT EN61000-4-4

Surge EN61000-4-5

CS EN61000-4-6

Voltage Dip EN61000-4-11

Harmonic EN61000-3-2

CE CE Compliant

Hold-up Time • @120VAC 10ms min. typ.

• @240VAC 40ms min. typ.

Storage Temp -30° C to +85° C

Approvals and

Standards - Safety

• cULus: UL/CSA60950

• TUV: EN60950

• CE: LVD, EMCD

MTBF 100,000 Calculated Hours

Environmental Specifications

Thermal Performance • 32°F to 104°F (0°C to 40°C)

• No Derating

• Convectional Cooling

• Non Vented Case

Relative Humidity Non-Condensing 5% to 95%

Altitude 0-10,000 feet

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

5/12

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com

93-0423-80 REV: C

Pin Connections

FIG. 2 describes the PoE Gigabit pin-out connections for the IN and OUT

Ports on the rear panel of the PS-POE-AF:

FIG. 2 PoE Gigabit pin-out connections

J2 J1

(Data IN)(Power and Data OUT)

(rear of unit)

POWER (+)

DATA Pins 4/5 (DATA + PWR)

DATA Pins 1/2 (DATA only)

DATA Pins 3/6 (DATA only)

POWER (-)

DATA Pins 7/8 (DATA + PWR)

Note: = Transformer

AMX PS-POE-AF Installation guide

Brand: AMX

Model: PS-POE-AF

Category: PoE adapters

Type: Installation guide

Download PDF

report

AMX PS-POE-AF Installation guide

AMX PS-POE-AF Installation guide

Related papers

Other documents