Alcatel 2000 Auto Dial Telephone
User Instructions
Features:
1. Telephone Number
2. Auto Dial Keypad
3. Ringer Pitch Control
4. Store
5. Clear
6. Ringer Volume Control
7. Hold Lamp
8. Hold
9. Recall
10. Pause
11. Redial
12. Incoming Speech Adjustment
13. Keypad
14. Mute Switch
To Make a Call
Lift the Telephone handset, listen for the dial tone and dial the required
number.
Refer also to the Redial feature.
Ringer Volume Control (6)
The slider switch (6) allows you to adjust the volume of the incoming ring to
the required level.
These levels are: HIGH, LOW, OFF
Ringer Pitch Control (3)
The incoming ring pitch can also be adjusted to your personal hearing
requirements by operating
the slider switch.
Incoming Speech Adjustment (12)
This switch allows the user to adjust the volume of the incoming speech to a
selection of three
volume levels.
Redial (11)
If you make a call and the number is engaged, or you need to call again the
number previously
dialled, you can redial the last number you dialled by simply lifting the handset
and pressing
the REDIAL key.
Auto-Dialling (2)
Up to 10 telephone numbers can be stored in the telephone memory and
dialled at the push of
a single button.
To Store Numbers:-
- Lift Handset
- Press and release the Store key (4)
- Key in the telephone number (entering the pauses as required for PABX
use).
- Press the Auto Dial Button (2) where the number is to be stored and record
the details on the
telephone number card.
- To change a number previously stored in the memory, simply repeat the
above operation - the
previous number will be automatically cancelled.
To Dial Stored Numbers-:
- Lift receiver
- Press the Auto Dial Button of the number you wish to call. The number will
be automatically dialled. To Dial Stored Numbers-:
- Lift receiver
- Press the Auto Dial Button of the number you wish to call. The number will
be automatically dialled.
Hold (8)
This feature allows the user to answer a call on one phone, place the call on
hold and continue
the call on either the same phone or a different phone on the same line.
To place a Call on Hold:
- Press HOLD button (8) while holding the handset.
- Replace the handset while still pressing the HOLD button.
- The RED LAMP (7) will be illuminated.
- Release the HOLD button.
To Resume Your Conversation:
- Lift the handset at the originating phone or any extension on the same line.
- After call, replace handset. All telephones on the line will return to normal
status.
Automatic Time Out:
This feature will automatically disconnect any call left on HOLD for
approximately five minutes.
Recall (9)
The recall button is used to transfer a call to another extension.
- Lift handset to answer call
- Press recall button (9)
- Dial extension number you wish to transfer the call to.
- Hang up when person answers at other end.
Pause (10)
The pause button is used when programing auto dial keys. e.g. 1 for an
outside line, followed by a pause, then the number to dial.
Mute (14) (under handset)
By depressing the MUTE button it is possible conduct a private conversation
with someone else in the same room without the caller hearing. Also stops
background noise being transmitted.
The caller is unable to hear for a long as the button is depressed.
-
1
-
2
-
3
