Aria A4601 Operating instructions

Aria
Brand
Aria
Model
A4601
Type
Operating instructions

This manual is also suitable for

Aria A4601 is a 4 input 6 output matrix A/V controller designed for whole-house audio systems.

The device is organized into 4 audio/video inputs and 6 audio/video outputs. It allows users to select any of the 4 source inputs and route them to any of the 6 outputs independently through the use of an IR repeating keypad (such as the A0127- Sold separately).

It is compatible with multichannel audio amplifiers, such as the A1260. The A4601R model is equipped with a rack mount faceplate to allow installations in a standard 19” equipment rack.

Aria A4601 is a 4 input 6 output matrix A/V controller designed for whole-house audio systems.

The device is organized into 4 audio/video inputs and 6 audio/video outputs. It allows users to select any of the 4 source inputs and route them to any of the 6 outputs independently through the use of an IR repeating keypad (such as the A0127- Sold separately).

It is compatible with multichannel audio amplifiers, such as the A1260. The A4601R model is equipped with a rack mount faceplate to allow installations in a standard 19” equipment rack.

CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase.
This is a no hassle warranty with no mail in warranty card needed. This warranty
does not cover damages in shipment, failures caused by other products not
supplied by Channel Vision Technology, or failures due to accident, misuse, abuse,
or alteration of the equipment. This warranty is extended only to the original
purchaser, and a purchase receipt, invoice, or other proof of original purchase date
will be required before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling (800) 840-
0288 toll free. A Return Authorization number must be obtained in advance and
can be marked on the outside of the shipping carton.
This warranty gives you specific legal rights and you may have other rights (which
vary from state to state). If a problem with this product develops during or after the
warranty period, please contact Channel Vision Technology, your dealer or any
factory-authorized service center.
500-059 rev E
Specifications: (typical @25º C)
Audio
Video
Bandwidth:
Crosstalk:
Dynamic Range:
THD:
Bandwidth:
Crosstalk:
20-20kHz
-90 dB
6.0 Vp-p
0.01%
DC-20MHz
-60 dB
Specifications subject to change without notice.
A4601
A4601R
4x6 Matrix Switcher
By
Aria
By Channel Vision
4x6 Matrix Switcher
A4601
Aria
By Channel Vision
4x6 Matrix Switcher
A4601
2
The A4601/A4601R... is a 4 input 6 output matrix A/V controller designed for
whole-house audio systems.
The unit is organized into 4 audio/video inputs and 6 audio/video outputs.
The A4601 is intended to be used with a multichannel audio amplifier, such
as the A1260.
Any of the 4 source inputs can be selected and routed to any of the 6
outputs (or zones) independent of the other zones through the use of an IR
repeating keypad (such as the A0127- Sold separately).
The A4601R is equipped with a rack mount faceplate to allow installations in
a standard 19” equipment rack.
Control of the A4601... is accomplished
through the use of an IR repeating device,
such as the A0127 keypad. The A0127
already contains the IR codes necessary
to operate the A4601, but you may also
use a standard IR receiver or a 3rd party
keypad. When using a simple IR receiver,
you will need to program a learning
remote control with the IR codes for the
A4601. These codes can be downloaded
from www.channelvision.com, or learned
from an A0127.
A4601/A4601R
4x6 A/V matrix controller
Aria
By Channel Vision
4x6 Matrix Switcher
A4600
Aria
By Channel Vision
4x6 Matrix Switcher
A4600
Pwr
Mute
Vid 1
Vid 2
Vid 3
Vid 4
Vol
+
Vol
-
A0127 IR-2001
IR-2202
CV
HANNEL ISION
TM
S
O
U
R
C
E
ZONE
POWER
MUTE
VOL
1
2
3
4
MODEL
A0501
POWER
CV
HANNEL ISION
TM
S
O
U
R
C
E
Z
O
N
E
P
OW
ER
M
U
T
E
V
OL
1
2
3
4
MODEL
A0501
P
O
W
E
R
Pwr
Mute
Vid 1
Vid 2
Vid 3
Vid 4
Vol
+
Vol
-
7
Using the A0501 remote control...
The A0501 is designed to allow you to control your A4601 without having to
touch the buttons on the A0127. Simply point the A0501 remote control at the
IR sensor located at the bottom of the A0127 and press the desired button.
Downloading IR commands for the A4601...
If you don’t have access to the A0501 remote and you need to program a
learning remote, you can download the IR codes from the internet. IR codes
compatible with the Philips Pronto remote controls can be downloaded from
the following websites:
(Hex codes are also available)www.channelvision.com
www.remotecentral.com
Zone Power - Turns on/off the zone you are in
Power - Master power for A4601 (turns all zones on/off)
Mute - Mutes the audio
for the zone you are in
VOL - Controls volume
for the zone you are in
Source Buttons
6
Wiring the A0127 keypad...
Keypads connect to the A4601 through the
RJ45 jacks on the back panel of the A4601.
Connections to the A0127 may be
accomplished either by using the RJ45 jack or
the screw terminals provided on the back side
of the keypad. When using the RJ45 jacks,
simply wire both ends of the cable according
to the TIA568A standard. When using the
screw terminals on the A0127, make sure to
wire the RJ45 plug connecting to the A4601
as shown below.
Connecting a standard IR repeater to the A4601... A standard
IR repeating device may be connected directly to the A4601
allowing the unit to be controlled from a learning IR remote. The
connection is similar to the wiring configuration shown above for
the A0127, except there are only three wires as shown below.
Note: not all IR receivers have the voltage,
ground, and signal connections in the same
order as this diagram. Pin 8: +VDC, Pin 7:
Ground, Pin 4: IR.
A0127
A4601
Front
Rear
Pin 7: Ground
Pin 8: +VDC
Pin 4: IR signal
Pin 8: +VDC
Pin 7: Ground
Pin 4: IR signal
N.C.
Typical IR receiver
connection
Pin 8: +VDC
Pin 7: Ground
Pin 4: IR signal
Pwr
Mute
Vid 1
Vid 2
Vid 3
Vid 4
Vol
+
Vol
-
Pin 8: +VDC
Pin 7: Ground
Pin 4: IR signal
Pwr
Mute
Vid 1
Vid 2
Vid 3
Vid 4
Vol
+
Vol
-
How IR repeating works
AB-500
Tx Batt
Rew<<
Play>
FF>>
Learn
Stop
Pause
12
3
4
5
6
7
8
9
0
Power
-/--
Ch
Vol
Learn
Error
All Off
Off
Select
Tuner
CD
Sat
VCR
DVD
TV
Channel Vision
TM
Point any IR remote control
at an IR receiver (such as
the A0127 shown here).
CD player
And the flasher
repeats the IR signal
in the other room.
Many IR receiving
devices provide an
indication that an IR
command has been
received.
On the A0127, the Pwr
button flashes as IR
information is received.
Be sure the flasher is attached
directly over the component’s IR
receiver.
3
A
ccessor
i
es
IR-3003 & IR-3002 ... Single and dual head
IR flashers. Use one head per source to
control from the remote room. (IR-3002
shown).
AB-500
Tx Batt
Rew<<
Play>
FF>>
Learn
Stop
Pause
1
2
3
4
5
6
7
8
9
0
Power
-/--
Ch
Vol
Learn
Error
AllOff
Off
Select
Tuner
CD
Sat
VCR
DVD
TV
ChannelVision
TM
AB-500 ... Universal remote control.. Learns
IR codes for up to 6 sources.
A0127 ... IR repeating keypad.
Preprogrammed to control the A4601 and is
capable of teaching its commands to a
learning IR remote control.
Pwr
Mute
Vid 1
Vid 2
Vid 3
Vid 4
Vol
+
Vol
-
OUTPUTS
FOR HOME OR OFFICE USE
Channel Vision A4601
Tested To Comply
With FCC Standards
R-Audio-L Video R-Audio-L Video R-Audio-L
3
46
5
OUTPUTS OU
TOUTPUTS
Control
5
6
Control
3
4 2
4
A4601 R
e
120
240
R
L
6
SPKR
IN
Local
Global
R
L
5
SPKR
IN
Local
Global
Global
10A 120V
5A 240V
Slow Blow
10A 120V
5A 240V
Slow Blow
Input Voltage
CAUT
I
RISK OF ELECT
R
DO NOT O
120 V~ 60 Hz
240 V~ 50 Hz
1000 W
120 V~ 60 Hz
240
V~ 50 Hz
1000
W
A1260
XXXX
A1260
XXXX
A1260 R
e
See page 6 for connection details
Pwr
Mute
Vid 1
Vid 2
Vid 3
Vid 4
Vol
+
Vol
-
Room 6
Each zone is controlled through the A0127 keypad which
connects to the RJ45 jacks on the rear panel.
INPUTS
Power
230/115VAC
50 / 60 Hz
Input Voltage
3
R-Audio-L Video
R-Audio-L Video
4
2
1
IR Emitters
1234
Hi-Z
75
Video
2
1
T
PUTS
OUTPUTS
Control
1
Sig
Gnd
+V
Video In
Termination
Video In
Termination
1A/250V
FUSE
115
Sat radio
DVD player
5
IR emitter outputs allow IR-3002 flashers to be connected for
remote control of source components.
When splitting the video signal from a source component, use
the dip switch to enable the Hi-Z mode on that input.
P
ower sw
i
tc
h
Switch for 110-120 or 220-240 operation
e
ar Panel
CD player
R
L
1
SPKR
IN
Local
Global
R
L
4
SPKR
IN
Local
Global
R
L
3
SPKR
IN
Local
Global
R
L
2
SPKR
IN
Local
Global
Aria Channel Visionby
Model A1260 12 Channel Amplifier
Made in China
!
I
ON
R
IC SHOCK
PEN
USE CLASS 2 WIRING FOR SPEAKER OUTPUTS
e
ar Panel
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Aria A4601 Operating instructions

Aria
Brand
Aria
Model
A4601
Type
Operating instructions
This manual is also suitable for

Aria A4601 is a 4 input 6 output matrix A/V controller designed for whole-house audio systems.

The device is organized into 4 audio/video inputs and 6 audio/video outputs. It allows users to select any of the 4 source inputs and route them to any of the 6 outputs independently through the use of an IR repeating keypad (such as the A0127- Sold separately).

It is compatible with multichannel audio amplifiers, such as the A1260. The A4601R model is equipped with a rack mount faceplate to allow installations in a standard 19” equipment rack.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents