Metra MPS-RZR01 Operating instructions

Category
Car kits
Type
Operating instructions

Metra MPS-RZR01 allows you to replace the factory radio with aftermarket ISO DDIN radios, matching the factory finish with its textured design. It provides a secure fit with screws and enables you to test the aftermarket equipment without disrupting factory connections. The kit includes a radio housing, Phillips screws, and is compatible with a wide range of Polaris RZR models from 2014 to 2019. For a seamless audio experience, consider adding Metra's 44-UA20 AM/FM antenna (sold separately).

Metra MPS-RZR01 allows you to replace the factory radio with aftermarket ISO DDIN radios, matching the factory finish with its textured design. It provides a secure fit with screws and enables you to test the aftermarket equipment without disrupting factory connections. The kit includes a radio housing, Phillips screws, and is compatible with a wide range of Polaris RZR models from 2014 to 2019. For a seamless audio experience, consider adding Metra's 44-UA20 AM/FM antenna (sold separately).

Metra. The World’s Best Kits.
®
MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 2/12/20 INSTMPS-RZR01
INSTALLATION INSTRUCTIONS
MPS-RZR01
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
KIT FEATURES
ISO DDIN radio provision
Replaces pocket/cover-plate
Textured to match factory finish
KIT COMPONENTS
• A) Radio housing • B) Phillips screws (5)
APPLICATIONS
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 1/8” drill bit
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Assembly ..........................................................3
A B
Polaris RZR 2014-2019
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle
specific applications
900 ...............................2015-2019
S 900 ............................2015-2019
4 900 EPS ..................... 2015-2017
S4 900 EPS ...................2016-2018
900 XC EDITION ............ 2015-2017
XP1000 .........................2014-2019
S 1000 ...........................2016-2019
S 4 1000 .................................2019
XP 4 1000 .....................2014-2019
XP TURBO .....................2016-2019
XP 4 TURBO ..................2016-2018
XP TURBO S ..................2018-2019
XP 4 TURBO S ........................2019
MetraOnline.com
2
DASH DISASSEMBLY
1. Remove the pocket from the lower
dashboard. (Figure A)
Continue to Kit Assembly
(Figure A)
REV. 2/12/2020 INSTMPS-RZR01
3
KIT ASSEMBLY
(Figure A) (Figure B)
1. Slide the radio into the radio housing,
then secure using screws supplied with
the radio. (Figure A)
2. Complete all necessary connections to
the radio, then test the radio for proper
operation. Use Metra part number
44-UA20 (sold separately) for an
AM/FM antenna.
3. Slide the radio assembly into the dash.
Pre-drill (5) pilot holes in the dash
using a 1/8” drill bit. Using a manual
screwdriver, secure the radio assembly
to the dash using (5) Phillips screws
provided. Do not overtighten! (Figure B)
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
®
Metra recommends MECP
certified technicians
Metra. The World’s Best Kits.
®
MetraOnline.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 2/12/20 INSTMPS-RZR01
INSTALLATION INSTRUCTIONS
MPS-RZR01
If you are having difficulties with the installation
of this product, contact our Tech Support line
either by phone at 386-257-1186, or email at
techsupport@metra-autosound.com. Before
doing so, look over the instruction booklet a
second time and ensure that the installation was
performed exactly as the instruction booklet
is stated. Have the vehicle apart and ready to
perform troubleshooting steps before contacting
Metra/Axxess Tech Support.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Metra MPS-RZR01 Operating instructions

Category
Car kits
Type
Operating instructions

Metra MPS-RZR01 allows you to replace the factory radio with aftermarket ISO DDIN radios, matching the factory finish with its textured design. It provides a secure fit with screws and enables you to test the aftermarket equipment without disrupting factory connections. The kit includes a radio housing, Phillips screws, and is compatible with a wide range of Polaris RZR models from 2014 to 2019. For a seamless audio experience, consider adding Metra's 44-UA20 AM/FM antenna (sold separately).

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI