Rosemount Rosemount 3300 Series Owner's manual

Type
Owner's manual

This manual is also suitable for

Emerson Rosemount 3300 Series radar level transmitter utilizes TDR technology to deliver continuous and precise level measurements in various industrial applications. Its key capabilities include:

  • Accurate measurement: Leverages Time Domain Reflectometry (TDR) to provide highly accurate level readings.

  • Non-contact operation: Eliminates the need for physical contact with the measured media, making it suitable for challenging environments.

  • Wide range of applications: Ideal for measuring levels in storage tanks, vessels, and process lines across various industries, including chemical, food & beverage, and power generation.

Emerson Rosemount 3300 Series radar level transmitter utilizes TDR technology to deliver continuous and precise level measurements in various industrial applications. Its key capabilities include:

  • Accurate measurement: Leverages Time Domain Reflectometry (TDR) to provide highly accurate level readings.

  • Non-contact operation: Eliminates the need for physical contact with the measured media, making it suitable for challenging environments.

  • Wide range of applications: Ideal for measuring levels in storage tanks, vessels, and process lines across various industries, including chemical, food & beverage, and power generation.

Manual Supplement
00809-0400-4811, Rev AA
May 2007
Rosemount 3300 Series
www.rosemount.com
Vapor Influence
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-2
Influence of Water Vapor . . . . . . . . . . . . . . . . . . . . . . . . . . page 1-2
Configuration of the 3300 transmitter . . . . . . . . . . . . . . . . page 1-3
This instruction is a supplement to the Rosemount 3300 Series Reference
Manual, see manual manual 00809-0100-4811.
Explosions could result in death or serious injury:
Before connecting a HART-based communicator in an explosive atmosphere, make
sure the instruments in the loop are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
Failure to follow safe installation and servicing guidelines could result in death or
serious injury:
Use the equipment only as specified in the Rosemount 3300 Series Reference Manual
(Reference number 00809-0100-4811) and in this manual supplement. Failure to do so
may impair the protection provided by the equipment.
Manual Supplement
00809-0400-4811, Rev AA
May 2007
Rosemount 3300 Series
1-2
INTRODUCTION The Rosemount 3300 Series Radar Transmitter is a smart, two-wire
continuous level transmitter that is based on Time Domain Reflectometry
(TDR) principles. Low power nano-second-pulses are guided along a probe
immersed in the process media. When a pulse reaches the surface of the
material it is measuring, part of the energy is reflected back to the transmitter
head, and the time difference between the generated and reflected pulse is
converted into a distance from which the total level or interface level is
calculated (see below).
For radar level gauging the actual measured quantity is the propagation time
through the empty space between the radar level transmitter and the liquid
surface. Important for the typical accuracy of a radar level transmitter is that
the propagation speed of the radar signal in most cases is very close to the
perfectly constant velocity of light in vacuum. However in some important
cases the deviation is not negligible and must be taken into account to get
high accuracy. High tank pressure in combination with certain gases are
examples.
INFLUENCE OF WATER
VAPOR
Water vapour at high pressure can have a big influence on radar level
transmitter measurements. This is due to the high pressure as well as the
polar structure of water molecules. In such cases the 3300 transmitter can be
configured to compensate for this effect by entering the dielectric constant of
the vapor.
Water has an unusual high critical temperature and pressure (374 ºC and 221
bar respectively, above which level measurement may be impossible), and in
power plants the use of water in the vicinity of those limits may occur. In a
closed vessel containing water liquid and water vapour existing data bases
(traditionally referred to as a Mollier diagram) have been used to calculate
pressure and vapour density and from this deduce the dielectric constant of
the vapour. The dielectric constant will change as given in the diagram below
covering the temperature range 0-360 °C.
Figure 1-1. Dielectric constant
versus temperature for saturated
water vapor
Dielectric constant
Pressure (Bar)
Dielectric constant
Temperatue (°C)
Pressure
Manual Supplement
00809-0400-4811, Rev AA
May 2007
1-3
Rosemount 3300 Series
CONFIGURATION OF
THE 3300 TRANSMITTER
The Rosemount 3300 transmitter is factory configured with a default value of
the dielectric constant of vapor above the product surface equal to 1. This
corresponds to the dielectricity of vacuum. For most vapors this value does
not need to be changed since the effect on measurement performance is very
small. For water vapor at high pressure the dielectric constant may be
significantly higher. The dielectric constant of vapor stored in the 3300
transmitter database can be changed by using a 375 Field Communicator, or
by using the Rosemount Configuration Tool (RCT).
When using the 375 Field Communicator the is available with HART
command [1,3,3,2]:
Figure 1-2. HART command for
configuration of Vapor Dielectric
Constant
In the RCT program the Vapor Dielectric Constant is found in the Setup
window / Tank Config tab:
Figure 1-3. Configuration of Vapor
Dielectric Constant in RCT program
Online Menu
1 DEVICE SETUP
2PV
3AO
4LRV
5URV
1 Measurement
Units
2 Geometry
Probe
3 Misc.
settings
4 Analog Output
5 Damping
Value
1 Process
Variables
2 Diag/Service
3 Basic Setup
4 Detailed Setup
5Review
1 Upper Null Zone
2 Vapor Dielectric
3 Product Dielectric
4 Measurement Mode
Click to open the
Vapor Dielectric Calculator
This value is
automatically
transferred when
pressing OK
Emerson Process Management
© 2007 Rosemount Inc. All rights reserved.
Rosemount and the Rosemount logotype are registered trademarks of Rosemount Inc.
PlantWeb is a registered trademark of one of the Emerson Process Management group of companies.
Teflon, VITON, and Kalrez are registered trademarks of DuPont Performance Elastomers.
Asset Management Solutions is a trademark of Emerson Process Management.
All other marks are the property of their respective owners.
Manual Supplement
00809-0400-4811, Rev AA
May 2007
Rosemount 3300 Series
Emerson Process Management
Shared Services Ltd.
Heath Place
Bognor Regis
West Sussex PO22 9SH
England
Tel 44 (1243) 863121
Fax 44 (1243) 867554
Emerson Process Management
Asia Pacific Private Limited
1 Pandan Crescent
Singapore 128461
Tel (65) 777-8211
Fax (65) 777-0947
Enquiries@AP.Emersonprocess.com
Rosemount Inc.
8200 Market Boulevard
Chanhassen, MN 55317 USA
T (U.S.) 1-800-999-9307
T (International) (952) 906-8888
F (952) 949-7001
www.rosemount.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Rosemount Rosemount 3300 Series Owner's manual

Type
Owner's manual
This manual is also suitable for

Emerson Rosemount 3300 Series radar level transmitter utilizes TDR technology to deliver continuous and precise level measurements in various industrial applications. Its key capabilities include:

  • Accurate measurement: Leverages Time Domain Reflectometry (TDR) to provide highly accurate level readings.

  • Non-contact operation: Eliminates the need for physical contact with the measured media, making it suitable for challenging environments.

  • Wide range of applications: Ideal for measuring levels in storage tanks, vessels, and process lines across various industries, including chemical, food & beverage, and power generation.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI