Specifications
Inventory
Figure 1
MODEL H8370
POWER FEED
FOR MILL/DRILLS
INSTRUCTIONS
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
&K'
'
(K'
)
*
+
-
,K'
Figure 1.
REF PART # DESCRIPTION
1V2 PH8370001V2 MOUNTING ASSY W/O WIRES V2.07.11
2 PH8370002 GEAR SAFETY COVER
3V2 PH8370003V2 PWR FEED & LIMIT SWITCH ASSY V2.07.11
4 PH8370004 LIMIT STOP
5 PH8370005 LIMIT SWITCH BRACKET
6 PH8370006 LEADSCREW GEAR
7V2 PH8370007V2 RAPID SWITCH W/LED V2.07.11
8 PH8370008 ZYTEL GEAR
If you need help with your new power feed, call
our Tech Support at: (570) 546-9663.
Wear safety glasses dur-
ing the entire setup pro-
cess!
Functional Overview
Figures 2–3
Figure 2.
Figure 3.
A. Direction Lever:
B. Rapid Movement Button:
ON
C. ON/OFF Switch:
D. Speed Dial:
E. Limit Stops:
F. Limit Switch:
Installation
Tools Needed Qty
To install the power feed:
1.
2.
3.
Figure 4
Figure 4.
4.
Figure 5
Figure 5.
5.
6. Step 5
7.
8.
Figure 6
9. Step 8
Figures 7–8
Figure 6.
Figure 7.
Figure 8.
Be sure there is enough running clearance
between the table, spindle, vise/clamps, or
jigs before turning the power feed ON. Be
aware that all of these objects represent
potential pinch points.
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. Compliance MUST
be verified by a qualified
electrician!
10.
Figure 9
Figure 9.
11.
12.
Figure 10
Figure 10.
13. OFF
Maintenance
1.
2.
3.
4.
5.
6.
/
