Read all information before using the device to ensure safe and proper use.
1. Please use the device within a temperature range of -10°C~+50°C and store the device and
its accessories within a temperature range of -10°C~+50°C. Extremely high or low
temperatures may cause malfunction of the device. The performance of battery may
compromise when temperature is lower than 5°C.
2. When charging, please keep the device in a well-ventilated area. Please charge this device
in an environment between 5°C and 35°C. If the product has a ash charging function, it may
not be able to enter the ash charging mode when the temperature is below 15°C or over
35°C.
3. The adapter, as the disconnect device from the mains, shall be installed near the device and
easily accessible.
4. Use manufacturer-approved chargers, data cables, batteries and other accessories to
prevent potential electric shock, re, explosion or other hazards.
5. Do not replace, disassemble, modify, mechanically crush or cut the battery, as it may cause
battery leakage, overheating, explosion or re.
6. Do not place the device or battery directly in sunlight, near/inside sources of heat or in a
low air pressure location, which may lead to an explosion or battery leakage.
7. The battery can be charged and discharged hundreds of times at least, but it will eventually
wear out.
8.The battery must be recycled or disposed of separately from household waste. Mishandling
the battery may cause re or explosion.
9.To prevent damage to your device's parts or internal circuits, do not use it in dusty, smoky,
damp or dirty environments or near magnetic elds.
10. If any part of the product is cracked or damaged, discontinue use immediately and contact
support@keychron.com
11. Power off your device in any area with a potentially explosive atmosphere, in blasting
areas/near blasting caps and comply with all signs and instructions.
12. Observe all safety instructions for any places, especially in hospital/health care facilities,
service stations, schools, professional garages and in an aircraft.
13. Do not use your device and adhere to all safety warnings/regulations regarding mobile
device usage while driving.
14. Persons with electronic implants (pacemakers, insulin pumps, neurostimulators, etc.) are
recommended to place the mobile telephone 15 cm away from the implant or on the opposite
side of the implant.
15. Do not leave your device and its accessories within the reach of small children or allow
them to play with it. They could hurt themselves or others, or may accidentally damage the
device.
16. Your device contains small parts with sharp edges that may cause an injury or which could
become detached and create a choking hazard. Children and Minors should use the device
under the supervision of a guardian to prevent swallowing.
BLUETOOTH / WIRED MODE (MODE TOGGLE SWITCH)
SWITCH BLUETOOTH DEVICES
1. Switch toggle to Cable; the mode requires a USB cable to be plugged in.
2. Connect the keyboard to your computer.
3. The keyboard backlighting will be activated.
*During Cable mode, the keyboard will not enter Battery Saver mode.
To switch between Bluetooth devices, short-press the key combinations: fn + 1 / fn + 2 / fn + 3.
WIRED MODE
1. Switch toggle to Bluetooth.
2. The keyboard backlighting will be activated.
3. Hold fn + 1 for 4 seconds to turn on Bluetooth pairing; the Bluetooth indicator will ash for 3 minutes while it
detects pairing.
4. Search for the Bluetooth device named “Keyboard 81 Pro” on your device and connect to it; the Bluetooth indicator
will change to indicate successful pairing.
Note: This keyboard supports pairing up to 3 devices simultaneously via key combinations: fn + 1 / fn + 2 / fn + 3.
*Slow or failed connections may occur due to different Bluetooth versions, please make sure all the settings are
correct.
BLUETOOTH MODE
