Cerio ANT-23AD Installation guide

Brand
Cerio
Model
ANT-23AD
Category
Flat panel wall mounts
Type
Installation guide
Installation Guide
5GHz 2x2 Outdoor Directional 23dBi with 1M N-Plug to SMA-Plug NFC200 Low Loss RF Cables Panel Antenna
1
CERIO Corporation
ANT-23AD
5GHz 2x2 Outdoor Directional 23dBi
with RF Cables Panel Antenna
Installation Guide
Technical Support
E-mail: support@cerio.com.tw
TEL: +886-2-8911-6160 #222
Web Site: www.cerio.com.tw
Installation Guide
5GHz 2x2 Outdoor Directional 23dBi with 1M N-Plug to SMA-Plug NFC200 Low Loss RF Cables Panel Antenna
Package Contents :
ANT-23AD Main Unit x1
Adjustable Pole & Wall Mounting Kit x1
RF Cables (NFC-NSP-1M) x2
Quick Installation Guide x1
Warranty Card x1
Main Unit Overview : (ANT-23AD)
RF Cable Overview : (NFC-NSP-1M)
Real
Front
2x2 SMA
Connect
Installation Guide
5GHz 2x2 Outdoor Directional 23dBi with 1M N-Plug to SMA-Plug NFC200 Low Loss RF Cables Panel Antenna
3
Installation:
1. Mount the antenna on the brackets according to the Mounting diagram. Make sure
the ANT-23AD antenna polarization parallel direction you needed. When the antenna
polarization are vertical to the ground, the antenna is vertical polarized. When the antenna
polarization are horizontal to the ground, the antenna is horizontal polarization.
2. Mount the ANT-23AD antenna on the antenna on the mast supplied by customer
according to the Mounting diagram.
3. Test the antenna with equipment to make sure the antenna receive the best signal by
turning the azimuth and pitching angle, then lock all the screws and seal the connector
between ANT-23AD antenna and NFC-NSP-1M RF cables with a waterproof cap.
No Surge arrester installation
Installation using a Surge arrester
Installation Guide
5GHz 2x2 Outdoor Directional 23dBi with 1M N-Plug to SMA-Plug NFC200 Low Loss RF Cables Panel Antenna
NO
DESCRIPTION
QTY
NO
DESCRIPTION
QTY
1
Bracket Panel
1
7
M4 flat washer
4
2
Bracket VV
1
8
M6 flat washer
12
3
5/32" Self tapping
screws
4
9
Hex Bolt M6x10L
4
4
Plastic wall plug
4
10
M6 Flange Nut
4
5
M6 wing nuts
4
11
V-bolt
2
6
M6 spring washer
8
12
4" Hose Clamps
2
ANT-23AD back plate
1. Pole Mount (Pole Range: Ø40-Ø100mm)
(Based on the panel antenna by 380x380mm)
Tilt angle adjustable by pole mount
mm
(in)
Side View
Drill 4 holes on the wall with following dimensions.
2. Alternative wall mount
No.11 Pole Range│Ø40-Ø50mm
No.12 Pole Range│Ø50-Ø100mm
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Cerio ANT-23AD Installation guide

Brand
Cerio
Model
ANT-23AD
Category
Flat panel wall mounts
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents