TO OBTAIN PARTS, PLEASE CONTACT:DONCO TRADING COMPANY - FORT WORTH, TEXAS
* Use of power tool to assemble this
product will invalidate any claim and
damage this product making unsafe !!!
* Please assemble on a clean soft
surface to avoid damage.
!Tools Required
(Not included)(Not included)
1:30 h
1- Follow the information on the warning label appearing on the upper bunk end structure and on the carton.
Do not remove warning label from bed.
2- Always use the recommended size mattress or mattress supporte, or both, to help prevent the likelihood of
entrapment or falls.
3- Surface of mattress must be at least 5 inchess below the upper edge of guardrails.
4- Do not allow children under 6 years of age to use the upper bunk.
5- Prohibit more than one person on upper bunk.
6- Periodically check and ensure that the guardrail, ladder and other components are in their proper position
free from damage, and that all connectors are tight.
7- Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8- Always use the ladder for entering and leaving the upper bunk.
9- Do not use substitute parts. Contact distributor or dealer for replacement parts.
10- Use of a night light may provide added safety precaution for a child using the upper bunk.
11- If the bunk bed will be placed next to a wall, the guardrail that runs the full length of the bed should be
placed against the wall to prevent entrapment between the bed and the wall.
12- Always use guardrails on both long sides of the upper bunk.
13- The use of water or sleep flotation mattresses is prohibited.
14- Keep these instructions for future reference.
15- Strangulation Hazard - Never attach or hang items to any part of the bunk bed that are not designed for
use with the bed: for example, but not limited to, hooks, belts, and jump ropes, etc.
3010 - T/T LOW LOFT TOP BED
00000
SEPTEMBER / 2018
DONCO TRADING CO.
MADE IN BRAZIL
MADE IN BRAZIL
CALIFORNIA93120.7(d) COMPLIANT FOR
FORMALDEHYDE PHASE 2
PO #:
MFG DATE:
FOR RESIDENTIALUSE ONLY
NOT FOR COMMERCIALUSE
PRODUCT:
MODEL#:
MFG CODE # :
PO # :
MFG DATE:
DISTRIBUTED BY: DONCO TRADING CO.
FORT WORTH, TX 76140
WARNING
!
California Proposition 65
This product can expose you to
chemicals, including formaldehyde
which is known to the
State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov/furniture.
TWIN LOW LOFT BED
JUNIOR
3005T
2
00000
SEPTEMBER/2018
8’’
Part list: 3010 - T/T Low Loft Top Bed
01
04
02
03
12
06
13
13
13
05
06
05
06
06
05
06
07
08
08
14
15
14
08
11
10
09
06
06
05
A
B
C
D
EH
I
G
F
32
24
16
11
07 32
0808
01
Ø10x40mm
White Connection
Ø7x110mm
Ø x 0mm77
Ø7 5x 0mm Ø4 3x 0mm
1/4 7x 0mm
4mm
CERTIFICATION LABEL
00000
SEPTEMBER / 2018
DONCO TRADING CO.
MADE IN BRAZIL
MADE IN BRAZIL
CALIFORNIA 93120.7(d) COMPLIANT FOR
FORMALDEHYDE PHASE 2
PO # :
MFG DATE:
FOR RESIDENTIAL USE ONLY
NOT FOR COMMERCIAL USE
PRODUCT: /T LOW LOFT TOPT BED
MODEL #: 3010
MFG CODE # : 000
PO # : 00000
SEPTEMBER / 2018
MFG DATE:
DISTRIBUTED BY: DONCO TRADING CO.
FORT WORTH, TX 76140
WARNING
!
This bunk bed model has been tested
by an independent laboratory and is
in compliance with ASTM F-1427
Standard Consumer Safety
Specification For Bunk Beds and the
Government Code of Federal
Regulations 1213 and 1513.
California Proposition 65
This product can expose you to
chemicals, including formaldehyde
which is known to the
State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov/furniture.
WARNING LABEL
DO NOT REMOVE! CERTIFICATION LABEL
DO NOT REMOVE!
TO HELP PREVENT SERIOUS OR FATAL INJURIES FROM ENTRAPMENT OR FALLS:
DO NOT REMOVE THIS LABEL
WARNING
Prohibit horseplay on or under bed(s).
Prohibit more than one person on the upper bunk.
Use ladder for entering and leaving upper bunk.
STRANGULATION HAZARD - Never attach or
hang items to any part of the bunk bed that are
not designed for use with the bed; for example,
but not limited to, hooks, belts, and jump ropes.
Never allow a child under 6 years on upper bunk.
Only use mattress which is 74”-75” long and 37 ½” - 38 ½”
wide and maximum high on upper and lower bunk.
Ensure thickness of mattress and foundation combined does
not exceed ” and mattress is at least 5” below upper edge8
8”
of guardrails.
Use guardrails on both sides of upper bunk.
.
.
.
.
___
CERTIFICATION LABEL
00000
SEPTEMBER / 2018
DONCO TRADING CO.
MADE IN BRAZIL
MADE IN BRAZIL
CALIFORNIA93120.7(d) COMPLIANT FOR
FORMALDEHYDE PHASE 2
PO #:
MFG DATE:
FOR RESIDENTIALUSE ONLY
NOT FOR COMMERCIALUSE
PRODUCT:TW
IN
TWIN BUNK BED
MODEL#: 3018
MFG CODE # : 000
PO # : 00000
SEPTEMBER / 2018
MFG DATE:
DISTRIBUTED BY: DONCO TRADING CO.
FORT WORTH, TX 76140
WARNING
!
This bunk bed model has been tested
by an independent laboratory and is
in compliance withASTM F-1427
Standard Consumer Safety
Specification For Bunk Beds and the
Government Code of Federal
Regulations 1213 and 1513.
California Proposition 65
This product can expose you to
chemicals, including formaldehyde
which is known to the
State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov/furniture.
TO HELPPREVENT SERIOUS OR FATALINJURIES FROM ENTRAPMENT OR FALLS:
DO NOT REMOVE THIS LABEL
WARNING
Prohibithorseplayonorunderbed(s).
Prohibit more than one person on the upper bunk.
Use ladder for entering and leaving upper bunk.
STRANGULATION HAZARD- Never attach or
hang items to any part of thebunk bed that are
not designed for use with the bed; for example,
but notlimited to, hooks, belts, and jump ropes.
Never allow a child under 6 years on upper bunk.
Only use mattress which is 74”-75”lo
ng and 37 ½”-
38 ½”
wide and maximuhigh on upper and lower bunk.
m 8’’
Ensure thickness of mattress and foundation combined does
not exceed”a
nd mattress is at least 5”b
elow upper edge
8
of guardrails.
Use guardrails on both sides of upper bunk.
.
.
.
.
___
06
01
FRONT RAIL WITH HOLES
(x4)
(x3)
(x3)
AB
32 24
Ø10x40mm White Connection
10
05
08
07
09
A
A
A
A
A
A
A
A
A
B
B
B
B
B
B
B
B
B
B
B
B
A
A
A
02
03
06
06
05
(x4)
CG
16 01
Ø7x110mm 4mm
05
05
05
05
06
06
01
02
04
03
06
06
06
06
06
06
C+GC+G
C+GC+G
C+GC+G
C+GC+G
C+GC+G
C+GC+G
C+GC+G
G+CG+C
G+CG+C
G+CG+C
G+CG+C
G+CG+C
G+CG+C
G+CG+C
G+CG+C
C+GC+G
G
CERTIFICATION LABEL
00000
SEPTEMBER / 2018
DONCO TRADING CO.
MADE IN BRAZIL
MADE IN BRAZIL
CALIFORNIA93120.7(d) COMPLIANT FOR
FORMALDEHYDE PHASE 2
PO #:
MFG DATE:
FOR RESIDENTIALUSE ONLY
NOT FOR COMMERCIALUSE
PRODUCT:T
WIN
TWINBUNK BED
MODEL#:3018
MFG CODE # :000
PO # :00000
SEPTEMBER / 2018
MFG DATE:
DISTRIBUTED BY: DONCO TRADING CO.
FORT WORTH, TX 76140
WARNING
!
Thisbunkbed model hasbeen tested
byan independent laboratoryand is
in compliance withASTM F-1427
Standard ConsumerSafety
SpecificationFor BunkBedsand the
GovernmentCode of Federal
Regulations1213 and 1513.
California Proposition 65
This product can expose you to
chemicals, including formaldehyde
which is known to the
State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov/furniture.
TO HELPPREVENT SERIOUS OR FATALINJURIES FROM ENTRAPMENT OR FALLS:
DO NOT REMOVE THIS LABEL
WARNING
Prohibithorseplayonorunderbed(s).
Prohibit more than one person on the upper bunk.
Use ladder for entering and leaving upper bunk.
STRANGULATION HAZARD- Never attach or
hang items to any part of thebunk bed that are
not designed for use with the bed; for example,
but notlimited to, hooks, belts, and jump ropes.
Never allow a child under 6 years on upper bunk.
Only use mattress which is 74”-75”l
ong and 37 ½”-
38 ½”
wide and maximumhigh on upper and lower bunk.
8’’
Ensure thickness of mattress and foundation combined does
not exceed”a
nd mattress is at least 5”b
elow upper edge
8
of guardrails.
Use guardrails on both sides of upper bunk.
.
.
.
.
___
Post number
here.
WARNING LABEL
DO NOT REMOVE!
CERTIFICATION LABEL
DO NOT REMOVE!
INSIDE
04
05 D
F08
1/4 7x 0mm
I08
D+G
G+D
G+D
G+D
G+F
I
I
II
II
G+F
D+G
F+G
F+G
G
G
INSERT AND
ATTACH SCREWS (F&I),
BUT DO NOT TIGHTEN UNTIL
STEP #08
INSERT AND
ATTACH SCREWS (F&I),
BUT DO NOT TIGHTEN UNTIL
STEP #08
G
G
06
Ø x 0mm77
01
01
4mm
4mm
II
II
II
G+FG+F
G+FG+F
F+GF+G
F+GF+G
08
08
08
D+GD+G
II
II
07
09
FRONT
06
07 DG
03 01
Ø x 0mm77 4mm
G+DG+D
G+DG+D
G+DG+D
G+EG+E
G+EG+E
E+GE+G
E+GE+G
E02
Ø7 5x0mm
G
EG
03 01
Ø7 5x0mm 4mm
E+GE+G
E+GE+G
E+GE+G
13
13
13
12
G
LADDER
08
09
!H
LSAT
``INSTALL SLAT KIT WITH SPACER
TAPE ON TOP(FACING UP)``
The first slats must be fixed at
3” from each headboard end.
!
H26
Ø4 3x0mm
15
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
HH
D
E
G
02
02
01
Ø x 0mm77
Ø7 5x 0mm
4mm
11
10
G
D+G
D+G
E+G
E+G
E+GE+G
AFTER ATTACHED
SCREWS E&D
AT THIS TIME,
PLEASE TIGHTEN
ALL SCREWS!
AFTER ATTACHED
SCREWS E&D
AT THIS TIME,
PLEASE TIGHTEN
ALL SCREWS!
11
10 H06
Ø4 3x0mm
14
14
HH
HH
HH
HH
HH
HH
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Donco 301 Assembly Instructions
-
-
-
-
-
-
-
-
-
Other documents
-
Julian Bowen NOV001 Assembly Instructions
-
Julian Bowen UP10115 Assembly Instructions
-
Julian Bowen MAI016 Assembly Instructions
-
Julian Bowen BAR015 Assembly Instructions
-
Julian Bowen BAR008 Assembly Instructions
-
Julian Bowen TRI601 Assembly Instructions
-
Donco Kids 1573 Assembly Instructions Manual
-
ROOMS TO GO 39118028 Assembly Instructions
-
-
