INSTALLATION GUIDE
76-U1236
( ALUMINUM )
https://rangerdesign.com/products/
oor-retainer-lip-for-shelving-units-
36-long-76-u1236/
For technical support, contact us at 1-800-565-5321 76-U1236 Installation Guide | REV. B | Page 2
QUICK START GUIDE
REQUIRED ITEMS
1 PERSON
1.1 Setup............................................................................................................................................... 3
Phase 1 - Assembly
Phase 2 - Installation
4
2.1 Regular Install.................................................................................................................................
Cordless Impact
Tape Measure
3/8" Socket
7/16” Socket
Hex Key 5/16”
Drill
Drill Stop Collar
Drill Bit 7/16”
Wrench 1/2”
SAFETY INSTRUCTIONS
WARNING
•Before the installation, carefully read the supplied installation guide to avoid possible injuries and dam-
ages resulting from incorrect installation. Always keep the installation guide in an accessible location at
all times for reference during installation.
•Installers must always wear appropriate safety gear during installation. This may include but is not limit-
ed to gloves, steel toed shoes, and safety glasses.
CAUTION
•Follow all vehicle manufacturer instructions before attempting any installation.
•To prevent rust and other damages, do not drill into the factory fl oor panels.
•Before drilling for the tapping inserts, use a drill stop collar to prevent accidental drilling the van met-
al fl oor panel which may result in damage to components underneath, such as wiring harnesses, fuel
tanks and battery modules.
For technical support, contact us at 1-800-565-5321 76-U1236 Installation Guide | REV. B | Page 3
PHASE 1 – ASSEMBLY
1.1 SETUP
1.1.1 Unpack components; compare with the bill of materials.
1.1.2 Verify all parts are present.
Item No. Description Qty.
70-027 Retainer Lip 36” 1
96-1200 Install Fastener Kit 1
BILL OF MATERIALS
96 - 1200 Fastener Kit Fastener Assembly
1.1.3 Fastener kits.
3×
3× # 92-102 Screw HWH tpAB #14x1”
70-027
3×
3×
Item No. Use with shelf width
76-U1236 36”, 72”, 84”
UNIT OPTIONS
# 92-102 Self tap
For technical support, contact us at 1-800-565-5321 76-U1236 Installation Guide | REV. B | Page 4
PHASE 2 – INSTALL
2.1 REGULAR INSTALL
2.1.1 • Place the retainer lip on the inside of the end
2.1.2B • Install the retainer lip to any other oor.
#92-102 Screw HWH tpAB #14x1”
TOOLS
Cordless Impact
3/8” Socket
HARDWARE USED
3×
View from rear of shelving
End Panel Retainer Lip
“You have successfully installed your Retainer Lip.
Thank you for doing business with us.”
For any feedback or suggestions you may have, please contact: [email protected]om
WITH E-FLOOR
WITHOUT E-FLOOR
2.1.2A • Install the retainer lip to the Ranger E-Floor. Use hardware provided with the
oor. See oor install guide for details.
#90-204 Hex Bolt
5/16" × 3/4"
#99-114 Wood Inserts
5/16”x13mm
Floor
NOTE: Use 5/16” washers and
lock-washers. (Not included)
TOOLS
Hex Key 5/16”
Drill
Drill Stop Collar
Drill Bit 7/16”
Wrench 1/2”
HARDWARE USED
3×
Center Post (for 72”,
84” & 96” shelving)
/
