2. FSR
  3. SYM-DIN-2AC-1CA-1VGA-1SS-AW

FSR SYM-DIN-2AC-1CA-1VGA-1SS-AW, SYM-DIN-2AC-2CA-1SS-AW, SYM-DIN-3AC-1CA-1SS-AW Installation guide

  • Hello! I've reviewed the FSR SYM-DIN Installation Instructions and understand how to install the table box assemblies, including selecting the location, cutting the hole, and inserting the assembly. I can also help with questions about removing the assembly, installing keystone connectors, and using blank inserts. Feel free to ask me anything about these instructions!
  • How do I remove the assembly from the table?
    What is the maximum radius for the corners of the hole cut out?
    What should I install if I am not installing keystone connectors right away?
FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43347 LIT1729A
TYPE FLANGE SIZE
A FRAME
B FRAME
C FRAME
D FRAME
6.30"
7.73"
8.69"
10.12"
CUT OUT SIZE
`
1/16
6-1/16"
7-7/16"
8-7/16"
9-7/8"
SYM-DIN Installation Instructions
1. SELECT LOCATION FOR ASSEMBLY AND CUT APPLICABLE HOLE
IN TABLE. INSERT ASSEMBLY INTO HOLE AND PUSH DOWN ON
FLANGES. TO REMOVE ASSEMBLY FROM TABLE, PRY BOTTOM
OF CAPTURE SPRING OFF ASSEMBLY FRAME.
SHARP TO 1/8" MAX
RADIUS CORNERS
ASSEMBLY
9-5/16"
`
1/16
CUT OUT
SIZE
FLANGE
SIZE
HOLE CUT OUT
TABLE
CAPTURE SPRING
TO REMOVE ASSEMBLY, INSERT
SCREWDRIVER THRU OPENING AND
PRY BOTTOM OF CAPTURE SPRING
OUT OF ASSEMBLY FRAME LIP, BOTH
SIDES. LIFT ASSEMBLY OUT OF HOLE
TO COMPLETE REMOVAL.
2.
INSERT INSTALLATION AND REMOVAL
a. TO INSTALL, PUSH INSERT WHERE INDICATED,
SNAPPING INSERT INTO ASSEMBLY.
b. TO REMOVE, INSERT SCREWDRIVER WHERE
INDICATED, PRYING INSERT OUT OF ASSEMBLY.
IF APPLICABLE, INSTALL KEYSTONE CONNECTORS (SOLD SEPARATELY) INTO
INSERTS (SINGLE OR DUAL), MAKE WIRING CONNECTIONS AS REQUIRED, AND
INSTALL INSERTS INTO ASSEMBLY. IF KEYSTONE CONNECTORS ARE TO BE
INSTALLED AT A LATER DATE INSTALL BLANK INSERTS. FRONT FACE MUST BE
CLOSED WITH KEYSTONE OR BLANK INSERTS.
PUSH HERE
PUSH HERE
INSERT SCREWDRIVER HERE
INSERT SCREWDRIVER HERE
/