2. Spectrum Industries
  3. 37344SMRB

Spectrum Industries 37344SMRB, 37344 Laminated Insert, 37344SMBK, 37344SMIG, 37344SMNR, Esports Laminate Leg Panel Inserts Owner's manual

  • Hello! I've reviewed the assembly instructions for the Leg Panel Insert 37344. This document provides guidance on installing the laminated leg panel insert for Esports Desks, explaining both a 3-screw and 4-screw installation method. I'm ready to answer your questions about the assembly process or the product itself.
  • What should I do before I begin the assembly?
    What should I do if any parts are damaged during shipment?
    What is the difference between the two installation methods?
Assembly InstructionsAssembly Instructions
11
22
33
11
22
33
44
0192117 Page 1 of 1
Assembly InstructionsAssembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2020 Spectrum Industries Inc., All rights reserved.
Laminated Leg Panel Insert - 37344Laminated Leg Panel Insert - 37344
for Esports Desksfor Esports Desks
(8) 037542
#8 x 5/8” PHSM
(2) 0151474
Laminated leg
panel insert
3 screw installation:3 screw installation:
(Pre-assembled desk)(Pre-assembled desk)
(does (does notnot require legs to be detached) require legs to be detached)
1. Carefully ip the desk upside down.
2. Set panel insert into each leg opening and secure
with (3) #8 x 5/8” PHSM screws as shown. Figure 1.
3. Carefully ip desk upright.
Figure 2
1. Carefully ip the desk upside down.
2. If legs aren’t already detached, remove the legs, remove the support
panel, cord channel fasteners, and leg-to-worksurface fasteners.
3. Set panel insert into each leg opening and secure with (4) #8 x 5/8”
PHSM screws as shown. Figure 2.
4. Re-attach each leg to the worksurface.
5. Re-attach the cord channel, and support panel.
6. Carefully ip the desk upright.
4 screw installation:4 screw installation:
(Unassembled or pre-assembled desk)(Unassembled or pre-assembled desk)
(requires legs to be detached)(requires legs to be detached)
Installation options:
Figure 1
LegLeg
Laminated
leg panel
insert
Laminated
leg panel
insert
/